1. Pipe Clips

2. Single Pipe Clip These are single plastic stand-off pipe clips.
This clip is used to hold single pipes.
When installing pipework set out your lines secure the clips, this holds your pipework in place.

3. Clip Lock
These as similar to the standard clips; they have the addition of a clip to hold the pipe in place.

4. Double Pipe Clip These hold two pipes at a standard distance apart.
They can give the work a uniform look.

5. Interlocking Clip Lock
These clips can be clipped together to form banks of as many as needed.
These can come as standard and locking clips.

6. Nail-on Pipe Clip Typically used on smaller bore pipe.
Care should be taken when using these clips as the expansion and contraction of the copper pipe can loosen the clip.

7. Copper Saddle Clip
These clips are good for clipping pipes to skirting boards and under floor boards due to there low profile.
These clips should not be used to hold copper pipe against masonry or plaster walls; as this can cause corrosion.

8. School Board Pipe Clip
These are used in light commercial and industrial installations.
These brackets give the pipe more rigidity minimizing any damage that might be cause.

9. Hospital Board Pipe Clip

10. Munsen Ring These clips are mainly used in industrial installations.
The bracket is screwed to the base plate.
This clip gives the strongest fixing of the clips.

11. Munsen Ring Back Plate
These are the back plates that the munsen ring screws onto.
These back plates can be screwed to the walls or ceilings.

12. Copper Pipe clip Spacing
Tube Size
Horizontal Distance Between Clips
Vertical Distance Between Clips
10mm
0.8m
1.2m
15mm
1.8m
22mm
2.4m
28mm
35mm
3.0m
42mm
54mm
2.7m

13. Iron School Board Clip
These clips are used to secure low-carbon steel pipe work.
The clip can be fixed to the wall and the pipe rested on it until it is clamped with the top bracket.

14. Iron Munsen Ring
These munsen rings have a threaded hole in both the bracket and back plate, this allows threaded bar be cut to length to adjust the distance of the pipe from the ceiling.
The clips come in plain finish or galvanized.

15. Low Carbon Steel Pipe Clip Spacing
Tube Size
Horizontal Distance Between Clips
Vertical Distance Between Clips ½”
1.8m
2.4m ¾”
3.0m 1”
1¼”
2.7m
1½”
3.6m

16. Waste Pipe Clip

17. Soil Pipe Bracket

18. Maximum Support Distance Maximum distance between expansion joint
PVCu Pipe Clip Spacing
Maximum Support Distance
Maximum distance between expansion joint
Vertical
Horizontal
Soil pipe size
82mm 2m
0.9m 4m
110mm 1m
160mm
Waste pipe size
32mm
0.5m
40mm
50mm

19. Polypropylene Pipe Clip Spacing
Maximum Support Distance
Maximum distance between expansion joint
Vertical
Horizontal
Waste pipe size
32mm
0.5m 2m
40mm
50mm
0.9m

20. Polybutylene Pipe Clip Spacing
Pipe diameter
Horizontal Distance Between Clips
Vertical Distance Between Clips
10mm
0.3m
0.5m
15mm
22mm
0.8m
28mm
1.0m