Presentation is loading. Please wait.

Presentation is loading. Please wait.

Preparing to Operate a Vehicle. Entering the Vehicle How should a driver approach when: Parked in a Parking Lot? Parked at a curb?

Similar presentations


Presentation on theme: "Preparing to Operate a Vehicle. Entering the Vehicle How should a driver approach when: Parked in a Parking Lot? Parked at a curb?"— Presentation transcript:

1 Preparing to Operate a Vehicle

2 Entering the Vehicle How should a driver approach when: Parked in a Parking Lot? Parked at a curb?

3 Before Entering the Vehicle Check around the outside of the vehicle for Broken glass (windows, lights, etc.), Body damage, Condition of tires, Fluid leaks, Direction of front tires, or Debris on the ground that could interfere with movement Pets/animals Small children or pets near vehicle.

4 Entering the Vehicle Key in Hand – Unlock Doors Store personal items in the trunk prevents theft and movement of unsecured items Control Door Swing Enter vehicle Check passengers for safe entry Lock Doors Insert Key into ignition

5 T – 2.2 Pre-DriveTasks Pre-Drive Tasks Sliding books or book bags on seats when slowing or stopping will distract the driver. Food or beverages also distract the driver from the driving task. Valuables visible in the car may attract a thief. Store personal items in trunk of vehicle When parked at the curb Approach vehicle from the front to monitor oncoming traffic. Approach driver’s door with key in hand. When parked in parking lot Approach vehicle from the rear to observe people or objects near the car. Approach driver’s door with key in hand.

6 Adjusting Driver’s Seating Position Adjust so heel can pivot smoothly between foot pedals Allow at least 10” between steering wheel and driver’s chest Top of head restraint should be even with top of ear Adjust the seat back for driver’s visual needs and vehicle control

7 Adjusting the Vehicle for You  Place back/shoulders against the back of the seat  Slightly bend knees  Rest right heel on floorboard between brake and accelerator  Sit high enough so top of steering wheel is between shoulders and chin  Use secured seat cushion if needed to raise seating height  Rest left foot on “dead pedal”

8 Adjusting the Head Restraint A head restraint that’s too low or too far back will not protect your head and neck in a crash. The four images below illustrate a typical impact.

9 Hand Position Correct Hand Position is 8 and 4 http://www.youtube.com/watch?v=og_zHqbWc2M&feature=related (1.5 min) http://www.youtube.com/watch?v=og_zHqbWc2M&feature=related

10 Push-Pull-Slide Steering How is it done? Why use it? Reduces excessive steering Reduces oversteering in emergency situations Reduces chance of injury during frontal crashes because arms do not cross in front of the air bag Push Pull Slide Steering Video: https://www.youtube.com/watch?v=pS3ECPrplKo

11 Why 8 and 4 Hand Position? Eliminates excessive steering Overcorrecting is the primary cause of young driver fatalities More stability control Protects forearms in the event of airbag deployment Reduces arm fatigue and back pain during long periods of driving Less wear on vehicle’s steering column

12 Hand-Over-Hand Steering How is it done? Most of your parents probably use Issues Arms sometimes cross Sometimes, only one hand is gripping the wheel Forearms are directly in front of wheel, in danger of being broken if airbag deploys Steering is often jerky, rather than smooth

13 Click it or Ticket Put on seat belt Make sure all passengers are buckled in also. It is the driver’s responsibility to ensure everyone is following the law. If a passenger who should be buckled is found to be unbuckled, the driver gets the ticket. Safety belts (seatbelts) are designed so the forces in a crash are absorbed by the strongest skeletal bones of the body: hip bone (pelvis) chest (sternum) shoulder

14 Safety Belts  Sit with shoulders and lower back firmly against seat  Snug the lap belt secured across rib cage and bony pelvic area  Adjust shoulder belt height with movable anchors on pillars so the belt does not rub against your neck  Check passengers for proper fit

15 Child Safety Seats & Booster Seats Passengers younger than 12 are safer sitting in the rear seat All children under age 8 must be secured in a child safety seat or booster seat. Children from birth to 1 year ride facing the rear. Children age 1+ ride facing forward in a child safety seat or booster seat ** The safest place to install a child safety seat is the center of the back seat.

16 SEATBELTS - PROTECTING OCCUPANTS Make everyone in the car wear a seatbelt video: https://www.youtube.com/watch?v=e6Qhmdk4VNs https://www.youtube.com/watch?v=e6Qhmdk4VNs https://www.youtube.com/watch?v=Q7aB98hZxBM https://www.youtube.com/watch?v=SSz6y-W-R_A Car seats: 2 min Silent crash dummy tests: https://www.youtube.com/watch?v=di0dSVJm-Rc https://www.youtube.com/watch?v=di0dSVJm-Rc

17 Location of gauges, controls, alert and warning symbols/lights varies from one vehicle to another Refer to vehicle owner’s manual for accurate use and directions Instrument panel is usually back-lit at night All gauges are working correctly when the lights turn off after starting the engine. Locating and Operating Vehicle Devices Instrument Panel Gauges and Lights

18 High beam indicator Oil Pressure ABS Alert/Warning Light Control, Information, Comfort, and Safety Devices

19 THEFT A. B. C. D. E. N. F. G. H. I. J. L. K. M. O. P. Q. R. S. Air Bag On/Off Switch Air Bag Functioning Antilock Brake System Functioning Theft-Deterrent System Activation 12 Volt Extension Outlet Battery/Alternator Warning Light Brake Warning Light Safety Alert Symbol Vent and Air Flow Control Door Locks Low Oil Pressure Warning Light Temperature Indicator Seat Belt Reminder Fog Lamps Drive Wheel Selector Emergency Flashers Fuse / Fuse Box Fuel Indicator Turn Signal Wipers Stalk T. Headlights/High Beam Indicator Locating and Operating Vehicle Devices Alert/Warning Symbols and Controls Worksheet

20 U. V. W. X.GG. Y. Z. AA. BB. CC. EE. DD. FF. HH. II. JJ. KK. LL. MM. O/D OFF Horn Hood ReleaseLighter Indicator Interior Light Adjustment Fan Speed Indicator Adjust Left/Right Side Mirror Parking Lamp Indicator Overdrive On/Off Indicator Exterior Lights Steering Wheel Height Adjustment Cruise Control Device Rear Defroster Indicator Power Window Controls Left/Right Signal Indicator Electronic Traction Control System Trunk Release Windshield Washer Windshield Wipers Front Windshield Defroster Locating and Operating Vehicle Devices Alert/Warning Symbols and Controls Worksheet ETS OFF

21 Accelerator and Brake Pedals Position the right heel of foot on the floor so the ball of foot can pivot between pedals Accelerator is used to maintain, increase, and/or decrease speed Brake is used to slow or stop vehicle Which pedal do you think you will use most often? Locating and Operating Vehicle Controls

22 Parking brake Small pedal located to the left of the driver or a hand-operated lever near the center console Used to hold vehicle in place when parked Can be used as an “emergency brake” Clutch pedal (Manual shift) Pedal located to the left of the brake Depress pedal to switch gears ease off clutch until friction point to smoothly engage engine

23 Ignition Switch or Remote Located on the dashboard Off/Accessories/On/Start Cruise/Speed Control Located on steering wheel, dash, or lever to the right of the wheel Allows vehicle to maintain constant speed and should be used only on dry pavement Locating and Operating Vehicle Controls

24 Ignition Switch

25 Located on steering column or center console Press button on end of lever P=Park, R=Reverse, N=Neutral, D=Drive (O/D overdrive on/off switch) 2=Stronger engine braking L=Maximum engine braking Brake pedal must be depressed to place vehicle in gear or park Locating and Operating Vehicle Controls Gear Selector Lever

26 Turn Signal Lever Located on left side of steering wheel Lift up for right turn, press down for left turn Lane change hold up or press down half way Hazard Flashers Located on steering column to the right or instrumental panel Windshield Wipers and Washer Control Part of turn signal lever in some vehicles Opposing lever on some vehicles Two controls: one for speed, one for washer fluid Locating and Operating Vehicle Devices

27 Headlights / Running Lights/Tail Lights Controlled usually by a knob or switch located on the left of the dash or a lever on the steering column Low to high beam pull toward you or push away On/Off: twist lever away or toward you to proper setting Locating and Operating Vehicle Devices

28 Operating Vehicle Control Devices Brake Pedal Used to stabilize speed. The driver can: -cover the brake- Placing the right foot over the brake but not applying pressure. -trail brake- (squeeze off) Use to maintain speed and balance, often used after controlled or threshold braking. -Controlled brake- (Squeeze on) Apply enough pressure to gradually stop the vehicle. -threshold brake- Braking to a point just short of wheel lock up. (Slamming on the brakes, emergency braking) - ABS - Antilock Braking system T-2.19

29 Operating Vehicle Control Devices Accelerator Pedal Used to increase and decrease speed. The driver can: cover the accelerator - To place right foot over the accelerator and be prepared to accelerator. progressive acceleration- to accelerate gradually to speed limit. lift off the accelerator- used to decrease speed gradually T-2.19

30 Fluid Leaks Air conditioner runoff = small puddle; clear (water) Radiator leak = noticeably large amount of water Windshield washer fluid = blue (traditionally) Transmission fluid = pink/red Oil = brown/black Brake fluid= yellow/brown Antifreeze = green Gasoline = rainbow (in light)

31 Traditional Mirror Setting VS. BGE Mirror Setting Traditional Mirror Setting BGE Mirror Setting

32 Traditional Mirror Settings Rear Mirror View Left Side Mirror View Right Side Mirror View

33 Rear Mirror View Right Side Mirror View Left Side Mirror View 15º BGE Settings

34 Setting your mirrors using BGE Rearview Mirror Should frame back window, not look into backseat Adjust each side mirror until you can barely see the side of your vehicle, so you maximize the view of the lane next to your vehicle Side View Mirrors Should shine out into blind spots, not at vehicle’s side. BGE mirror settings Driver‘s Side Place your head against the driver’s side window and adjust the driver’s side mirror so you can barely see the driver’s side of your car. Passenger Side Move your head as close to the center of the car as possible and adjust the passenger’s side mirror so you can barely see the passenger’s side of your car. http://www.youtube.com/watch?v=KwzUE6PHk4U

35 Blind Glare Elimination Setting The BGE enhanced side mirror settings (15 degrees to outside) eliminates right and left side mirror blind areas ENHANCED LEFT SIDE MIRROR VIEW ENHANCED RIGHT SIDE MIRROR VIEW REAR MIRROR VIEW

36 BGE: Blind Glare Elimination Advantages of BGE mirror settings Visible space in the mirror doesn’t overlap More space can be seen without turning your head Allows you to monitor the adjacent lane Blind spots are made smaller Only need a quick glance into blind spot Greatly reduces glare from headlights of following vehicles

37 Check/set park brake (P) and place Right foot on brake pedal, heel on floor Left foot on “dead pedal” for balance Key in ignition, and turn toward start Check alert, warning lights and gauges Adjust ventilation, accessories, etc Turn headlights on Starting Tasks

38 Starting Tasks: Final Steps Adjust climate control. Put your foot on the brake. Check parking brake: ensure that it’s off. Either hand brake or foot brake Put vehicle in gear.

39 Find a legal, safe parking place Find a legal, safe parking place Stop and set parking brake Stop and set parking brake Shift gear selector to (P)ark Shift gear selector to (P)ark (Shift to Reverse if Manual Transmission) (Shift to Reverse if Manual Transmission) Close windows Close windows Turn off accessories Turn off accessories Turn ignition switch to “off” Turn ignition switch to “off” Lock ignition switch and remove key Lock ignition switch and remove key Unfasten occupant restraints Unfasten occupant restraints Securing the Vehicle

40 Reference Points Relates a part of the vehicle to some part of the roadway Reference Points - Relates a part of the vehicle to some part of the roadway

41 Front Reference Point When using the front reference point you should relate the side view mirrors to a part of the road way. Driver’s Side mirror is just above the stop line. This reference point lets you know the front of the vehicle is just behind the stop line. When parking the vehicle the you should also use your front reference point. When the Mirror appears to be just above the curb you know your vehicle is all the way in the spot and not hanging over the curb.

42 Rear Reference points When you are backing up out of a parking spot or parallel parking you should use your rear reference point. When the rear corner of the car next to you is in the middle of the rear passenger window you should start to turn the wheel.


Download ppt "Preparing to Operate a Vehicle. Entering the Vehicle How should a driver approach when: Parked in a Parking Lot? Parked at a curb?"

Similar presentations


Ads by Google