Presentation is loading. Please wait.

Presentation is loading. Please wait.

 What is the density of a population?  The number of individuals per unit area  Dispersion is how they spread out in that area  What are the three.

Similar presentations


Presentation on theme: " What is the density of a population?  The number of individuals per unit area  Dispersion is how they spread out in that area  What are the three."— Presentation transcript:

1

2  What is the density of a population?  The number of individuals per unit area  Dispersion is how they spread out in that area  What are the three patterns of dispersion?

3  Clumped dispersion has population occurring in patches  Increased concentration of resources leads to clumping  Defense against predators  e.g. schools of fish

4  Even spacing of individuals within the population  Diminishes competition  Often seen with plants, they secrete chemicals that prevent germination and growth of individuals that may compete for resources.

5  Spacing is varied and unpredictable  Occurs in the absence of strong attraction (concentrated resources) or strong repulsion (avoidance of competition) between individuals.  This form of dispersal is rare.

6  Mark re-capture method.  You capture 200 grasshoppers, mark them all and then release them back into the wild. A few days later you capture 100 grasshoppers and 50 of them were marked. How many grasshoppers do you estimate are in this population?  N = # marked x total captured second time number marked recaptures  200 x 100/50 = 400

7  What changes can effect density?  Immigration  Emigration  Births  Deaths

8  What is demography?  Study of vital statistics that affects population size  age structures - relative numbers of individuals at each age. Used to tell if a population is increasing, decreasing or staying the same  birthrate, death rate, generation time and sex ratios, all affect interpretation of age structures

9  Summarize the survival pattern of a population  Follows the fate of a cohort (group of individuals of the same age) from birth until death  Shows the proportion of the cohort surviving from one age to the next

10

11  What is a survivorship curve?  Graphic display of the life table  Plot of the numbers of a cohort that are alive at each age.  Survivorship curves are generally classified into three types:

12

13  Type I : Low death rate in early years.  Small clutch sizes and good care for young  Type II: constant mortality throughout life  Type III: large clutch size, little care for young high mortality rate early on in life.

14

15  Age specific summary of reproductive rates in a population.  Measures the reproductive output of a cohort from birth until death.  Tallies number of female offspring for each age group.

16

17  Semelparity – Organisms reproduces only once in its lifetime. Examples: salmon, agave (century plant)  Iteroparity - Organisms reproduce repeatedly throughout their lifetime.

18  What is the life history of an organism?  Traits that affect time of reproduction and death. 1. Clutch size 2. Number of reproductive episodes per lifetime 3. Age at first reproduction

19

20

21  Number of reproductive episodes:  Large clutch sizes mean one reproductive episode per life.  Small clutch sizes means more than one reproductive episode  Age at first reproduction is younger in large clutch size reproducers, they invest less energy in their own growth and development.

22  Births and Immigration increase the population.  Deaths and Emmigration decrease the population.  (Births + Immigration) – (Deaths + Emmigration) = Change in population size.

23  r = reproductive rate, r = b-d/N  b = births, d = deaths, N = population size  multiply both sides of the equation by N, we get: Nr = b-d, Nr = change in population during a given time interval, =  N/  t * Immigration and emmigration are ignored for simplicity

24  r = reproductive rate, r = b-d/N  b = births, d = deaths, N = population size  multiply both sides of the equation by N, we get: Nr = b-d, Nr = change in population during a given time interval, =  N/  t = b - d  r max = maximal population growth  If deaths exceed births r is negative  If deaths equal births r is zero (no growth)  If births exceed deaths, population is growing.

25 r max = 1 r max =.5

26

27  J shaped curve  Unlimited population growth, due to unlimited resources.  r selected populations favor the exponential growth curve. Seen in areas with little competition  Opportunistic species display this pattern, grasses, insects…  But all populations eventually have a limit placed on their growth...

28  Limiting factors will affect the size of a population  Equation becomes: dN/dt = r max N (K-N/K)  K = carrying capacity, varies over space and time  When the population is low, N is small and K- N/K is close to 1, so r is close to r max  As N approaches K, K-N/K approaches zero and therefore r approaches zero and the population is no longer increasing or decreasing in size.

29 What is occurring here? N is greater than K, so r is negative, deaths exceed births ? K

30 What is occurring here? N is less than K, so r is positive, births exceed deaths K

31

32

33 K selected species - likely to be living at carrying capacity, seen in areas with competition

34 r selected  short maturation time  short life-span  high death rate  many offspring/reproduction  one reproductive event  reproduces early in life  small size to offspring  no parental care K selected  long maturation time  long lifespan  low death rate  few offspring/reproductio n  several reproductive episodes  reproduces later in life  large sized offspring  parental care for young

35

36 1. How is a population growing when N is very small? 2. What changes are occurring when N approaches K? 3. What happens when N is greater than K? 4. What are characteristics of r selected species? 5. What are some characteristics of K selected species?

37  Density dependent factors  Intensifies as population grows.  Density independent factors  Affects same number of individuals regardless of population size.  A predator is which sort of limiting factor?  Density dependent.  A hurricane is which sort of limiting factor?  Density independent.

38  Density-dependent factors increase their affect on a population as population density increases.  This is a type of negative feedback.  Density-independent factors are unrelated to population density, and there is no feedback to slow population growth. Copyright © 2002 Pearson Education, Inc., publishing as Benjamin Cummings Fig. 52.13

39 What sort of limiting factor is seen here?

40

41

42

43  Human population is no longer growing exponentially, but is still increasing rapidly.  Population still growing, but rate of growth is decreasing.  Result of changes due to diseases, including AIDS, and voluntary population control.

44

45

46  Population Dynamics vary from region to region.  Zero Population = High birth rate – High Death Rate  Zero Population = Low Birth rate – Low Death rate  Move from first to second called demographic Transition.

47

48  Shows relative number of individuals of each age in the pyramid.  Bottom heavy, lots of youth that will grow up reproduce and sustain explosive growth.  Small base, small number of reproductive individuals.  Also predicts social conditions.

49

50 1. Which population is k - selected, Type I, Type II or Type III? 2. Determine if the following are density dependent or density independent factors. a. Tornado b. Infectious disease c. Food 3. Draw an age structure that displays a population that is increasing.


Download ppt " What is the density of a population?  The number of individuals per unit area  Dispersion is how they spread out in that area  What are the three."

Similar presentations


Ads by Google