Presentation is loading. Please wait.

Presentation is loading. Please wait.

SISTEM KONVERSI ENERGI ANGIN (WIND ENERGY CONVERSION SYSTEMS-WECS) Oleh: Malik Ibrochim (13 Oktober 2011-S1) – (9 Desember 2011- S2)

Similar presentations


Presentation on theme: "SISTEM KONVERSI ENERGI ANGIN (WIND ENERGY CONVERSION SYSTEMS-WECS) Oleh: Malik Ibrochim (13 Oktober 2011-S1) – (9 Desember 2011- S2)"— Presentation transcript:

1 SISTEM KONVERSI ENERGI ANGIN (WIND ENERGY CONVERSION SYSTEMS-WECS) Oleh: Malik Ibrochim (13 Oktober 2011-S1) – (9 Desember 2011- S2)

2 OUTLINES RESOURCES WECS COMPONENTS WIND TURBINE TYPE WIND TURBINE DESIGN

3 RESOURCES The Geostrophic Wind The winds we have been considering on the previous pages on global winds are actually the geostrophic winds. The geostrophic winds are largely driven by temperature differences, and thus pressure differences, and are not very much influenced by the surface of the earth. The geostrophic wind is found at altitudes above 1000 meters (3300 ft.) above ground level. The geostrophic wind speed may be measured using weather balloons. Surface Winds Winds are very much influenced by the ground surface at altitudes up to 100 meters. The wind will be slowed down by the earth's surface roughness and obstacles, as we will learn in a moment. Wind directions near the surface will be slightly different from the direction of the geostrophic wind because of the earth's rotation (cf. the Coriolis force ). When dealing with wind energy, we are concerned with surface winds, and how to calculate the usable energy content of the wind. © Copyright 1997-2003 Danish Wind Industry Association Updated 1 June 2003 http://www.windpower.org/en/tour/wres/geostro.htm

4 RESOURCES The earth receives 1.74 x 10 17 watts of power (per hour) from the sun About one or 2 percent of this energy is converted to wind energy (which is about 50-100 times more than the energy converted to biomass by all plants on earth Differential heating of the earth’s surface and atmosphere induces vertical and horizontal air currents that are affected by the earth’s rotation and contours of the land  WIND. ~ e.g.: Land Sea Breeze Cycle

5 Winds are influenced by the ground surface at altitudes up to 100 meters. Wind is slowed by the surface roughness and obstacles. When dealing with wind energy, we are concerned with surface winds. A wind turbine obtains its power input by converting the force of the wind into a torque (turning force) acting on the rotor blades. The amount of energy which the wind transfers to the rotor depends on the density of the air, the rotor area, and the wind speed. The kinetic energy of a moving body is proportional to its mass (or weight). The kinetic energy in the wind thus depends on the density of the air, i.e. its mass per unit of volume. In other words, the "heavier" the air, the more energy is received by the turbine. at 15° Celsius air weighs about 1.225 kg per cubic meter, but the density decreases slightly with increasing humidity. RESOURCES

6 10 m50 m Kelas Kec.Angi n Kategori Rapat Daya (W/m 2 ) Kecepata n Angin Rata-rata (m/s) Rapat Daya (W/m 2 ) Kecepata n Angin Rata-rata (m/s) 1 Sangat Kurang 0-1000-4,40-2000-5,6 2Kurang100-1504,4-5,1200-3005,6-6,4 3Cukup150-2005,1-5,6300-4006,4-7,0 4Baik200-2505,6-6,0400-5007,0-7,5 5 Sangat Baik 250-3006,0-6,4500-6007,5-8,0 6 Luar Biasa 300-4006,4-7,0600-8008,0-8,8 7 Sangat Luar Biasa 400-10007,0-9,4800-20008,8-11,9 KLASIFIKASI POTENSI ENERGI ANGIN Pramod Jain, WIND ENGINEERING, McGraw-Hill, 2011

7 KLASIFIKASI ASSESSMENT POTENSI ENERGI ANGIN J.C. Hansen, N.G. Mortensen, J. Badger, N.E. Clausen and P. Hummelshøj, “Opportunities for wind resource assessment using numerical and observational wind atlases: modeling, verification and application”, Wind Power Shanghai 2007

8 PERBANDINGAN SKALA ASSESSMENT POTENSI ENERGI ANGIN (PETA POTENSI) SKALA MESO SKALA MIKRO Renewable Energy Authority (NREA) and Risø, “Wind Farm Planning at the Gulf of Suez”, Risø, Roskilde, Denmark, 2004 Perbandingan Peta Potensi Energi Angin Skala Meso (menggunakan metoda KAMM) dan Mikro. Perhitungan dilakukan pada ketinggian 25 m dari atas permukaan tanah, dengan z 0 = 0,2 mm

9 PARAMETER ANALISIS STATISTIK

10 POWER TRANSFER FROM WIND TO GRID

11 WIND TURBINE COMPONENTS

12 WIND TURBINE COMPONENTS (IG)

13 WIND TURBINE COMPONENTS (PMSG)

14 Types of Wind Turbines “Darrius” Vertical Axis Wind Turbine Large Horizontal Axis Wind Turbine Traditional Windmill

15 Airfoil Aerodynamics Wind = V 0 Rotation = r *  Relative Wind = W  Wind Speed and Turbine Rotation must be combined to find total velocity that airfoil sections “see”

16

17  A typical 600 kW wind turbine has a rotor diameter of 43-44 meters, i.e. a rotor area of some 1,500 square meters.  The rotor area determines how much energy a wind turbine is able to harvest from the wind.  Since the rotor area increases with the square of the rotor diameter, a turbine which is twice as large will receive 2 2 = 2 x 2 = four times as much energy.  To be considered a good location for wind energy, an area needs to have average annual wind speeds of at least 12 miles per hour.

18 LARGE TURBINES: Able to deliver electricity at lower cost than smaller turbines, because foundation costs, planning costs, etc. are independent of size. Well-suited for offshore wind plants. In areas where it is difficult to find sites, one large turbine on a tall tower uses the wind extremely efficiently. WIND TURBINE SIZING

19 SMALL TURBINES:  Local electrical grids may not be able to handle the large electrical output from a large turbine, so smaller turbines may be more suitable.  High costs for foundations for large turbines may not be economical in some areas.  Landscape considerations WIND TURBINE SIZING

20 Wind Turbines: Number of Blades  Most common design is the three-bladed turbine. The most important reason is the stability of the turbine. A rotor with an odd number of rotor blades (and at least three blades) can be considered to be similar to a disc when calculating the dynamic properties of the machine.  A rotor with an even number of blades will give stability problems for a machine with a stiff structure. The reason is that at the very moment when the uppermost blade bends backwards, because it gets the maximum power from the wind, the lowermost blade passes into the wind shade in front of the tower.

21 Wind power generators convert wind energy (mechanical energy) to electrical energy. The generator is attached at one end to the wind turbine, which provides the mechanical energy. At the other end, the generator is connected to the electrical grid. The generator needs to have a cooling system to make sure there is no overheating.

22 22 Wind Turbine Concepts Active stall/stall wind turbine  Fixed Speed  Squirrel-Cage Induction Generator  Soft-starter, Capacitor Bank Pitch control wind turbine  Variable Speed  Squirrel-Cage Induction Generator  Back-to-Back Power Converter

23 23 Wind Turbine Concepts Pitch control wind turbine  Variable Speed  Double-Fed Induction Generator  Back-to-Back Power Converter Pitch control wind turbine  Variable Speed  Multi-Pole Synchronous Generator – direct driven  Rectifier + Inverter

24 SMALL GENERATORS:  Require less force to turn than a larger ones, but give much lower power output.  Less efficient i.e.. If you fit a large wind turbine rotor with a small generator it will be producing electricity during many hours of the year, but it will capture only a small part of the energy content of the wind at high wind speeds. LARGE GENERATORS:  Very efficient at high wind speeds, but unable to turn at low wind speeds. i.e.. If the generator has larger coils, and/or a stronger internal magnet, it will require more force (mechanical) to start in motion.

25 Wind Turbine Design

26

27

28 What is The Best Rotor to Generator Ratio for a Given Wind Resource?

29 Fix Speed Vs Variable Speed

30 Wind Turbine Design Optimization Model

31

32  A wind turbine built so that it too severely interrupts the airflow through its cross section will reduce the effective wind velocity at its location and divert much of the airflow around itself, thus not extracting the maximum power from the wind.  At the other extreme, a wind turbine that intercepts a small fraction of the wind passing through its cross section will reduce the wind’s velocity by only a small amount, thus extracting only a small fraction of the power from the wind traversing the wind turbine disk.  Modern wind turbine can attain an efficiency of about 60 % of the theoretical maximum.

33 SELESAI DAN TERIMAKASIH Generator dan Elektronika Daya Turbin Angin Gearbox dan Bearing Turbin Angin Aerodinamika Turbin Angin


Download ppt "SISTEM KONVERSI ENERGI ANGIN (WIND ENERGY CONVERSION SYSTEMS-WECS) Oleh: Malik Ibrochim (13 Oktober 2011-S1) – (9 Desember 2011- S2)"

Similar presentations


Ads by Google