1. Mitsubishi I-MiEV
Isolation Procedure

2. Precautions
Fully electric vehicles present risks to the repairing technician. Additional equipment and PPE will be required, together with specialist training for safe handling.
Correct powering down of the high voltage system will require compliance with a specific method.
Failure to do so could expose the technician to high voltage and risk of death.

3. High Voltage Battery Disconnection
Work on the High Voltage system must only be performed by specialist personnel who are aware of the safety instructions and precautions to be taken.
High Voltage insulated gloves and tools must be used to carry out any work on High Voltage system components.
All work must be carried out in line with current Health and Safety regulations.

4. Safety Precautions
Before working on any part of the high voltage system be sure to have the following:
Insulating gloves
Leather gloves
Face mask/ visor
Insulated tools
High voltage multi-meter(cat 4 calibrated and working)
Insulating bags
Warning notices/barriers(vehicle and work location)
Locking device

5. Lock Out Procedure
Lockout is a safety procedure intended to protect persons working on electric vehicles from accidents and from any inadvertent appearance or reappearance of voltage on the vehicle.
The Isolation and Lock out procedure should be carried out prior to carrying out repairs or touching:
Vehicle High Voltage Parts
2. Vehicle High Voltage Harness or Connections

6. 1.Pre Checks
Identify that you are working on the correct vehicle(reg. No./chassis no.)
Confirm that the vehicle is not on charge
Place safety notices on the vehicle and barriers around work area if required.
Put on PPE ready to start isolation procedure
Note: All metal or conductive objects must be removed from your person or insulated to prevent accidental contact with live conductors or components

7. 2. Switch off ignition and wait 1 minute
Check that no power consumers are switched on
Using a multi meter check for 12v only at the auxiliary battery

8. 3. Disconnect auxiliary battery and wait 5 minutes
Secure the positive lead with an insulated bag with a warning label attached

9. 4. Slide LH front seat forward or remove
Remove covering material from over service plug(secured by velcro- not shown in picture)
Remove service cover plug

10. 5.
Remove service plug and securely lock away with vehicle key to prevent accidental reinsertion
Insulate plug connection on the high voltage battery and attach warning label

11. 6.
Remove high voltage motor cover(situated in boot)

12. 7. Remove the service access panel on the top of the inverter
Rubber weather seal must be renewed when cover is refitted

13. 8.
Check for 0 Volts at terminals illustrated using a high voltage multi meter to ensure the high-voltage system is fully isolated
Multi meter should be Category 4 and checked it is working correctly prior to this check

14. 9.
Disconnect high voltage cables to inverter(as illustrated)and secure in an insulated bag with warning labels attached
The vehicle should now be isolated and safe to carry out any further repairs
Any components to be worked on should be checked also for 0 Volts before removal as close to the component as possible

15. 10. Re-instatement
Re-instatement is the reversal of the isolation procedure
After vehicle has been re-instated back to pre isolation condition the following checks must be made to ensure the vehicles safety.
An insulation test of the cables must be carried out after they have been refitted
Always ensure that the test equipment is in good working order immediately before and after each check
Always ensure that the correct CPE and PPE is used
It is strictly prohibited to check for the absence of voltage or
potential equalisation without using the correct equipment,
CPE and PPE which is designed for this purpose.