1. 14:650:388 Computer-Aided Drafting in Mechanical Engineering Group 8 – Centinaro, Joseph S. Daskaloski, Damjan Group 8 – Centinaro, Joseph S. Daskaloski, Damjan King, Joseph Liu, Daniel Norbut, Donald J. King, Joseph Liu, Daniel Norbut, Donald J.

2. Project: HONDA CBX 1989 Motorcycle Engine

3. Cylinder Block 1 2

4. Small Parts 8 7 9

5. Engine Head 6 4 5

6. Cam Shafts and Gears

7. Crankshaft

8. Pistons, Valves and Caps

9. Casing Top Top Part of Crank shaft case Bottom Part of Crank Shaft Case

10. Mechanism of “4- stroke Engine”/ Timing`

11. Timing Camshaft Timing Camshaft and piston timing

12. Gear Connections

13. Difficulties and Obstacles Engine head was an extremely difficult piece: Many extrusions Many difficult areas to measure Certain Parts within the head are unreachable Bulky and had to be measured in the lab

14. Difficulties (cont’d) Cam follower connections: 24 valves meant that 24 cam- follower connections needed to be made Extremely slow process on DSV computers Original caps had flat surfaces on the top, but a cam follower works much better with a rounded surface

15. Improvements and Modifications Exhaust - Straightened for better air flow - In a drag race the rider is typically laying flat on the bike, so an angled exhaust is not necessary

16. Improvements and Modifications (cont’d) No cooling vents were made: Since this engine head was made for a drag race it will not heat up long enough to need cooling vents Simplifies machining and design

17. Animation

18. Animation (cont’d)