2. Cascadia ParkSmart System Introduction

3. What is ParkSmart? A complete air conditioning and heating system for the Cascadia sleeper.

4. The ParkSmart system is fully powered by the truck’s alternator and electrical system. Engine On

5. Engine off is powered by highly efficient auxiliary batteries. Engine Off

6. Before July 2011After July 2011

8. Temps can be pulled down easily in drive mode, but it’s better not to pull down high temps in “engine off” mode. Temperature

9. Blower TemperatureBunk Override

10. Blower Temperature Sleeper Auxiliary Control Unit

11. Blower Temperature

12. Sleeper Auxiliary Control Unit LED Light

13. Sleeper Auxiliary Control Unit 60 degrees 85 degrees

14. The system automatically maintains the sleeper temp after you set the control unit. Automatic Start Up

15. Maintaining Your Set Temperature The temperature adjusts automatically, the blower is set by you.

16. Espar Hydronic 5 Unit If the engine is cold when you turn on the heater, it takes a few minutes to produce heat.

17. 1. Pre-cool the sleeper temperature for longer run time. 5 Ways to Get the Most Out of Your System 2. Close the sleeper curtain to keep the temperature constant. 3. Block out heat from the sun. Park the truck away from the sun and use a windshield reflector. 4. Keep the air intake at the lower cabinet door clear. 5. Drive for 4 to 6 hours to recharge the ParkSmart batteries.

18. Maintenance Recommendations

19. After July 2011

20. Air Filter

21. Use Park mode 15 – 20 minutes a month.

22. For more information Visit nitesystem.com or call 866.204.8570