1. PINHOLE PHOTOGRAPHY

13. How does a Pinhole work?

14. “How can the sun can make a circular image when it shines through a square hole?” Aristotle (350 B.C.)

16. http://www.youtube.com/watch?v=RuJ_Jd 6Qgyo&feature=relatedhttp://www.youtube.com/watch?v=RuJ_Jd 6Qgyo&feature=related

17. Believed that most Renaissance (14-17 th C.) artists used Camera Obscura, but only a few admitted it. Leonardo and Michelangelo were know to use it.

18. Camera Obscura Lens added in 1600s for sharper images.

19. Joseph Niepce (1862) First permanent photograph Varnish on metal plates

20. Two ways to control exposure

21. The small hole on the Pinhole is just a VERY tiny F-Stop

25. Small Pin Hole f/182 6 sec exposure Large Pin Hole f/65 1/5 of a sec Lens f/16 1/100 of a sec

26. Ann Hamilton http://www.pbs.org/art21/artists/hamilton/cl ip2.html#http://www.pbs.org/art21/artists/hamilton/cl ip2.html#

27. Artists who work with pinhole cameras: Legacy Project “The Great Picture”

33. F-18 Fighter plane hanger from WWII El Toro MCAS Orange County, California Picture taken: July 2006

34. Worlds Largest Pinhole camera and Photograph

42. Two parts to our box: Lid and Bottom

43. Lid: Step 1 Cover center piece with black paper. Front Back

44. Lid: Step 2 Place sides next to center leaving VERY small gap. (smaller than shown) Put masking along 4 edges, leaving VERY small gap.

45. Lid: Step 3 1.Flip over so that masking tape is on the bottom. 2.Pull sides up to create corners. 3.Tape corners. 4.Glue along INSIDE seams on sides and bottom

46. Lid: Step 4 1.Once Glue is dry, carefully take off masking tape. If any of your seams come apart, tape and glue again. 2. Rip Black Duct Tape into strips 3. Push strips of Duct Tape hard along seams on outside of box. All strips need to overlap!!! This is making box light tight. ****Make sure to stop just before the bottom of the box along the edges.

47. Bottom of Box

48. Bottom: Step 1 Cover one side of all 4 pieces with black paper. Front Back

49. Bottom: Step 2 Place sides next to center leaving VERY small gap. (smaller than shown) Put masking along 4 edges, leaving VERY small gap.

50. Bottom: Step 3 1.Flip over so that masking tape is on the bottom. 2.Pull sides up to create corners. 3.Tape corners. 4.Glue along INSIDE seams on sides and bottom Front

51. Bottom: Step 4 1.Once Glue is dry, carefully take off masking tape. If any of your seams come apart, tape and glue again. 2. Rip Black Duct Tape into strips 3. Push strips of Duct Tape hard along seams on outside of box. All strips need to overlap!!! This is making box light tight. ****Make sure to stop just before the bottom of the box along the edges.