1. FLT CTRL NO DISPATCH Return to Service Procedures NOTE: FOR TRAINING PURPOSES ONLY. IT DOES NOT SUPERSEDE EMBRAER OFFICIAL DOCUMENTATION

2. FLIGHT CONTROLS – DISPATCH PROCEDURES Issue: Jan, 2005 Rev.:00 1 AIRCRAFT MAINTENtANCE MANUAL (AMM) PART II – MAINTENANCE PROCEDURE Go to Return-to-Service Test (AMM Part II – Task 27-00-00-070- 801-A) 1

3. FLIGHT CONTROLS – DISPATCH PROCEDURES Issue: Jan, 2005 Rev.:00 2 ACCESS THROUGH CMC... 2

4. FLIGHT CONTROLS – DISPATCH PROCEDURES Issue: Jan, 2005 Rev.:00 3 NVM CLEARING TEST: GO TO: 27 Flight Controls 03 Flight controls System; NVM CLEARING TEST 3

5. FLIGHT CONTROLS – DISPATCH PROCEDURES Issue: Jan, 2005 Rev.:00 4 NOTE: CONFIRM ALL OF FCM STATUS SHOW PASSED. START NVM CLEARING TEST 4

6. FLIGHT CONTROLS – DISPATCH PROCEDURES Issue: Jan, 2005 Rev.:00 5 CLEAR NVM 5

7. FLIGHT CONTROLS – DISPATCH PROCEDURES Issue: Jan, 2005 Rev.:00 6 START FCS OPS TEST 6

8. FLIGHT CONTROLS – DISPATCH PROCEDURES Issue: Jan, 2005 Rev.:00 7 NVM CLEARING TEST (4 of 7) NOTE: in the begining of this step, observe that all of indicating dots are RED. After the item #1, the half of them becomes GREEN and after item #3, all of them will turn to GREEN. CAUTION: It’s very important to ensure that the Control Column is really moved to the STOPS and stays there for at least 3 (THREE) seconds. CAUTION: When cycling the FCP switch, when pressing it, wait 3 seconds before press it again to cycle the actuator 7

9. FLIGHT CONTROLS – DISPATCH PROCEDURES Issue: Jan, 2005 Rev.:00 8 NVM CLEARING TEST ( 5 of 7 ) NOTE: in the begining of this step, observe that all of indicating dots are RED. After the item #1, the half of them becomes GREEN and after item #3, all of them will turn to GREEN. CAUTION: It’s very important to ensure that the Rudder Pedals really are moved to the STOPS and stays there for at least 3 (THREE) seconds. CAUTION: When cycling the FCP switch, when pressing it, wait 3 seconds before press it again to cycle the actuator 8

10. FLIGHT CONTROLS – DISPATCH PROCEDURES Issue: Jan, 2005 Rev.:00 9 NVM CLEARING TEST ( 6 of 7 ) 9

11. FLIGHT CONTROLS – DISPATCH PROCEDURES Issue: Jan, 2005 Rev.:00 10 NVM CLEARING TEST ( 7 of 7 ) Note: It’s important to confirm that all of indicating dots on NVM CLEARING are GREEN. If one or more still RED, you must repeat the entire procedure. 10

12. FLIGHT CONTROLS – DISPATCH PROCEDURES Issue: Jan, 2005 Rev.:00 11 FINALLY, CHECK THE EICAS DISPLAY.. THE MESSAGES: FLT CTRL NO DISPATCH FLT CTRL FAULT ARE NO LONGER PRESENTED ON EICAS DISPLAY 11 THEN... Power Down and Power Up the ACFT as required per SNL-170-27-0007.