2. Arc Welding 6832 10:01-02

3. Cost less AC welders cost ______ than DC welders.

4. Carbon Arc Torch When hard surfacing, you can attach a ______ torch to the welder.

5. E6011 The best all purpose welding rod is E _______.

6. Bare end Electrodes are measured by the _______ end of the rod.

7. Most comfortable What position is the best position for you to weld in?

8. Remove the slag Before welding a second pass you should remove the ______.

9. TIG or MIG Which welder has no slag?

10. 12 or 14 TIG and MIG welders should use a ____ shade lens because the arc is brighter than an arc welder.

11. Small area MIG welders concentrate the heat in a ______ area.

12. Gas and Wire When you change from welding steel to aluminum on a MIG welder you may need to change the gas and the ______.

13. 4 When measuring wire feed inches per minute, you can measure how much wire comes out of the welder for 15 seconds and then multiply times ______.

14. Molten pool What part of the weld should you watch?

15. Base plate When making a tee, most of the heat should be on the ________ _______.

16. Position Welding pipe is difficult because the welding ________ keeps changing.

17. Wide Welding too slow makes the weld bead too _______.

18. Narrow Welding too fast makes the weld bead too _______.

19. Ceramic Cup One way to increase the size and rate of gas around a TIG weld is to change the ________ _______.

20. Carbon Dioxide Using _____________ as a gas shield for TIG and MIG welders causes excessive splatter.