Download presentation
Published byShonda McCormick Modified over 8 years ago
1
Vehicle Registration Details Extraction System Using GSM
2
AGENDA Introduction Block Diagram Power Supply&Testing
Micro-Controller&Testing GSM module&Testing RFID module&Testing IR Sensor LCD module&Testing Problems Refference
3
Introduction Heavy Rainy season Chances of accident
To Control the Traffic Rule The project addresses microcontroller based Vehicle Registration details Extraction system using GSM
4
Block Diagram
5
CKT DIAGRAM
6
Power Supply Regulated dc power supply Output=5v component
7
Testing of Power Supply
8
Microcontroller ■ 80C51 Central Processing Unit
■5 V Operating voltage from 0 to 40 MHz ■64 kB of on-chip Flash program memory ■ Four 8-bit I/O ports with three high-current Port 1 pins ( 16 mA each) ■Three 16-bit timers/counters ■Programmable Watchdog timer (WDT) ■Eight interrupt sources with four priority levels TTL- and CMOS-compatible logic levels
9
Testing of Microcontroller
10
FACED PROBLEMS Crystal Reset Power Supply Poor pin contacts
Syntax Errors Undefined Symbol
11
GSM Module
12
Features of GSM Single supply voltage 3.2v-4.5v
Typical power consumption in SLEEP Mode: 2.5mA. SIM300 tri-band
13
Testing with a PC Connect the GSM Modem to a PC COM Port
Create a HyperTerminal (Windows tool for serial port communications) window with Baud rate 9600 and connect it to the COM Port to which GSM is connected. Type any AT command in the HyperTerminal window and you could see the modem responding by sending “OK”.
14
Testing with a PC
15
Faced Problems Connections setting Matching proper Baud rate
Serial port communication
16
IR Sensor Obstacle detection
17
Testing OF IR Sensor
18
RFID Module Radio-frequency identification(RFID)
An RFID system is just a reader and a tag communicating over the air at a certain frequency Parts – Readers – Antennas – Tags Fig 1: An RFID tag used for electronic toll collection.
19
LCD • 2 line x 16 character Display
• Each character location consist of 5 dot x 8 bit display 4bit or 8bit MPU interface Memory map
20
Testing OF LCD Establish connection with Microcontroller
Load Program for transmitting string. Check Data lines of LCD. Adjust Potentiometer.
21
PROBLEMS Loose Connection. LCD Initialization.
Display String operation LED+ LED-
22
Refference Timo H.,Javier R. and Jaun M.2003.GSM,GPRS and Performance and Ed. Chichester:John Wiley And Sons,Ltd. I.Pottier and G.Burel,” Identification and authentication of handwritten signatures with a connectionist approach,” in Proc.IEEE Int.
23
THANK YOU
Similar presentations
© 2025 SlidePlayer.com. Inc.
All rights reserved.