1. 박 유 진

2.  2.4-GHz IEEE 802.15.4 Compliant RF Transceiver  Excellent Receiver Sensitivity ( -97dBm) and Robustness to Interference  6-mm × 6-mm QFN40 Package  Low Power Operation Mode  Active-Mode RX (CPU Idle): 24 mA  Active Mode TX at 1 dBm (CPU Idle): 29 mA  Power Mode 1 (4 ms Wake-Up): 0.2 mA  Power Mode 2 (Sleep Timer Running): 1 mA  Power Mode 3 (External Interrupts): 0.4 mA

3.  High-Performance and Low-Power 8051 Microcontroller Core With Code Prefetch  32-, 64-, 128-, or 256-KB In-System-Programmable Flash  8-KB RAM With Retention in All Power Modes  Hardware Debug Support

4.  Powerful Five-Channel DMA  IEEE 802.15.4 MAC Timer, General-Purpose Timers (One 16-Bit, Two 8-Bit)  32-kHz Sleep Timer With Capture  12-Bit ADC With Eight Channels  CSMA/CA Hardware Support  Accurate Digital RSSI/LQI Support  Two Powerful USARTs With Support for Several Serial Protocols

5.  Battery Monitor and Temperature Sensor  AES Security Coprocessor  21 General-Purpose I/O Pins (19× 4 mA, 2× 20 mA)  Watchdog Timer

7. MetricCC2430CC2530 MCU8051 Compatible FlashUp to 128KUp to 256K RAM8K(<4K During PM2/3)8K(in All PMs) Clock Loss DetectionNoYes Timer 1 Channels35 MAC Timer Size16-bit, 20-bit overflow16-bit, 24-bit overflow Core Freq32 MHz Package7 x 7 48pin6 x 6 40pin Operation Temperature-40 to +85-40 to +125

8. MetricCC2430CC2530 Max TX Power(dBm)0+4.5 Sensitivity(dBm)-92-97 Link Budget(dB)92101.5 EVM at max output power11%2% Adjacent -5MHz3049 Adjacent +5MHz4149 Adjacent -10MHz5357 Adjacent +10MHz5357

9. MetricCC2430CC2530 Operation Voltage2.0 – 3.6V Rx Current27 mA24 mA Tx Current(0 dBm)27 mA29 mA Tx Current(+4.5 dBm)NA34 mA CPU active current(32 MHz)10.5 mA6.5 mA PM1 current190 uA200 uA PM2 current0.5 uA1 uA PM3 current0.3 uA0.4 uA PM1 -> Active4 uA PM2/3 -> Active0.1 mA Xtal startup time0.5 ms0.3 ms

11.  8KB SRAM  32-, 64-, 128-, or 256-KB In-System-Programmable Flash  Flash Controler  32-bit word programmable  Page erase(2KB)  Lock bits for write protection and code security  Flash-page erase timing 20 ms  Flash-chip erase timing 20 ms  Flash-write timing (4 bytes) 20 ms

12.  DMA Controler  Five independent DMA channels  Three configurable levels of DMA channel priority  32 configurable transfer trigger events  Independent control of source and destination address  Single, block and repeated transfer modes  Supports length field in transfer data, setting variable transfer length  Can operate in either word-size or byte-size mode

13.  21 digital input/output pins  General-purpose I/O or peripheral I/O Select  Pullup or pulldown capability on inputs  External interrupt capability(General-Purpose I/O Interrupts)  Peripheral I/O Pin Mapping  Can select Peripheral I/O Pin 2 Alternative Locations

14.  Peripheral I/O Pin Mapping(con’t)

15.  Power Down Mux  output the 32 kHz clock(Port 0)  output the digital regulator status(Port 1)  If set PDM, ignore all other Peripherals

16.  RF Core  provides an interface between the MCU and the radio  Modulator/Demodulator  Transmit/Receive data in compliance with the IEEE 802.15.4 standard  Use FSM(Finite State Machine)  Frequency Synthesizer(FS)  CSMA/CA Coprocessor  Radio RAM(TXFIFO/RXFIFO)  MAC Timer(Timer 2)

17.  DSSS(Direct Sequence spread spectrum)  2MHz Chip Rate(250K Data Rate)  4bit Symbol Code  32bit Chip Code  OQPSK  CSMA/CA  Use Command Strobe Processor