1. Hydraulic turbine

2. History
Water wheels have been used for thousands of years for industrial power. Their main shortcoming is size, which limits the flow rate and head that can be harnessed.
The migration from water wheels to modern turbines took about one hundred years.
Development occurred during the Industrial revolution, using scientific principles and methods.
They also made extensive use of new materials and manufacturing methods developed at the time.

3. Swirl
The word turbine was introduced by the French engineer Claude Burdin in the early 19th century and is derived from the Latin word for "whirling" or a "vortex".
The main difference between early water turbines and water wheels is a swirl component of the water which passes energy to a spinning rotor.

4. New concept Main article: Pelt on wheel
All common water machines until the late 19th century (including water wheels) were basically reaction machines; water pressure head acted on the machine and produced work.
A reaction turbine needs to fully contain the water during energy transfer.

5. Theory of operation
Flowing water is directed on to the blades of a turbine runner, creating a force on the blades.
Since the runner is spinning, the force acts through a distance (force acting through a distance is the definition of work).
In this way, energy is transferred from the water flow to the turbine

6. Water turbines are divided into two groups
reaction turbines
impulse turbines.

7. Reaction turbines: Francis Kaplan, Propeller, Bulb, Tube, Straflo
Tyson
Gorlov

8. reaction turbines
Newton's third law describes the transfer of energy for reaction turbines.
Most water turbines in use are reaction turbines and are used in low (<30m/98 ft) and medium (30-300m/98–984 ft) head applications. In reaction turbine pressure drop occurs in both fixed and moving blades.

9. Impulse turbine Waterwheel Pelton Turgo Crossflow Jonval turbine
Reverse overshot water-wheel
Archimedes' screw turbine

10. Impulse turbines.
Newton's second law describes the transfer of energy for impulse turbines.
Impulse turbines are most often used in very high (>300m/984 ft) head applications

11. Pumped storage
Some water turbines are designed for pumped storage hydroelectricity.
They can reverse flow and operate as a pump to fill a high reservoir during off-peak electrical hours, and then revert to a turbine for power generation during peak electrical demand.
This type of turbine is usually a Francis in design.

12. Efficiency
Large modern water turbines operate at mechanical efficiencies greater than 90%
(not to be confused with thermodynamic efficiency).

13. Design and application
Turbine selection is based mostly on the available water head, and less so on the available flow rate.
In general, impulse turbines are used for high head sites, and reaction turbines are used for low head sites.

14. Kaplan turbines with adjustable blade pitch are well-adapted to wide ranges of flow or head conditions, since their peak efficiency can be achieved over a wide range of flow conditions

15. Environmental impact Main article: Environmental impacts of reservoirs
Water turbines are generally considered a clean power producer, as the turbine causes essentially no change to the water.
They use a renewable energy source and are designed to operate for decades.
They produce significant amounts of the world's electrical supply.

16. Made by darshan kachhadiya

17. Thank you