1. Intro to Semiconductors and p-n junction devices
Continuing with Chapter 11 (semiconductors)

2. Band Diagram: Insulator
Conduction band
(Empty)
T > 0 EC
Egap EF EV
Valence band
(Filled)
At T = 0, the lower valence band is filled with electrons and the upper conduction band is empty, leading to zero conductivity.
Fermi energy: EF is at midpoint of large energy gap (2-10 eV) between conduction and valence bands.

3. Band Diagram: Intrinsic Semiconductor
Conduction band
(Partially Filled) EC EF EV
Valence band
(Partially Empty)
At T = 0, lower valence band is filled with electrons and upper conduction band is empty, leading to zero conductivity.
Fermi energy EF is at midpoint of small energy gap (<1 eV) between conduction and valence bands.

4. Donor Dopant in a Semiconductor
For group IV Si, add a group V element to “donate” an electron and make n-type Si (more negative electrons!).
“Extra” electron is weakly bound, with donor energy level ED just below conduction band EC.
Dopant electrons easily promoted to conduction band, increasing electrical conductivity by increasing carrier density n.
Fermi level EF moves up towards EC. EC EV EF ED
Egap~ 1 eV
n-type Si

5. Band Diagram: Acceptor Dopant in Semiconductor
For Si, add a group III element to “accept” an electron and make p-type Si (more positive “holes”).
“Missing” electron results in an extra “hole”, with an acceptor energy level EA just above the valence band EV.
Holes easily formed in valence band, greatly increasing the electrical conductivity.
Fermi level EF moves down towards EV. EA EC EV EF
p-type Si

6. pn Junction: Band Diagram
pn regions “touch” & free carriers move
Due to diffusion, electrons move from n to p-side and holes from p to n-side.
Causes depletion zone at junction where immobile charged ion cores remain.
Results in a built-in electric field (103 to 105 V/cm), which opposes further diffusion.
Note: EF levels are aligned across pn junction under equilibrium.
n-type
electrons EC EF EF EV
holes
p-type
pn regions in equilibrium – – EC – – + – + – EF + + – – – + + + – – + + – + + + EV
Depletion Zone

7. Forward Bias and Reverse Bias
Forward Bias : Connect positive of the positive end to positive of supply…negative of the junction to negative of supply
Reverse Bias: Connect positive of the junction to negative of supply…negative of junction to positive of supply.

8. PN Junction: Under Bias
Forward Bias: negative voltage on n-side promotes diffusion of electrons by decreasing built-in junction potential  higher current.
Reverse Bias: positive voltage on n-side inhibits diffusion of electrons by increasing built-in junction potential  lower current.
Equilibrium
Forward Bias
Reverse Bias
p-type
n-type
p-type
n-type
p-type
n-type –V +V e– e– e–
Majority Carriers
Minority Carriers

9. pn Junction: IV Characteristics
Current-Voltage Relationship
Forward Bias: current exponentially increases.
Reverse Bias: low leakage current equal to ~Io.
Ability of pn junction to pass current in only one direction is known as “rectifying” behavior.
Forward
Bias
Reverse Bias
Manifestly not a resistor: V=IR
Not Ohm’s law

10. Devices: Light-related
Absorption: incoming photon creates electron-hole pair (solar cell).
Spontaneous Emission: electron-hole pair spontaneously decays to eject photon (LED).
Stimulated Emission: incoming photon stimulates electron-hole pair to decay and eject another photon, i.e. one photon in  two photons out (LASER).
Energy E2 2 1 1 1 2 2 3 E1
Absorption
Spontaneous
Emission
Stimulated
Emission

11. LED Solar Cell Light-emitting diode (LED)
Converts electrical input to light output: electron in  photon out
Light source with long life, low power, compact design.
Applications: traffic and car lights, large displays.
Solar Cell
Converts light input to electrical output: photon in  electron out (generated electrons are “swept away” by E field of pn junction)
Renewable energy source!
LED
Solar Cell
Phys Baski
Solid-State Physics

12. LED-Electrical Properties-Hetero junctions

13. Laser Diodes Similar to LED structure with degenerate doping.
Degenerate doping- where fermi level is ( ) on P-side is in the valence band (VB)and on the N-side is in the conduction band (CB).
When there is no applied voltage the fermi level is continuous across the diode. .

15. Laser Diode (Population Inversion)
More electrons in the CB at energies near Ec than electrons in VB near Ev.
This is the result of a Population Inversion in energies near EC and EV.
The region where the population inversion occurs develops a layer along the junction called an inversion layer or active region.