Download presentation
Presentation is loading. Please wait.
Published byRodney Robinson Modified over 8 years ago
1
Comments on optical system for calibration Jan Smolik, Jaroslav Zalesak Institute of Physics, Prague
2
Dec 19, 2007Jan Smolik2 Present system: one tile – one optical fibre → it is very complicated system Idea: use one fibre for more tiles, ideally one row of tiles – one fibre How to do it? ➔ Side-emitting fibre ➔ Classical end-emitting fibre with some “damage” effecting side-lighting
3
Dec 19, 2007Jan Smolik3 Side-emitting fibres ● In principal the easiest solution – to buy, lace through tiles and connect to LED driver ● Problem to find thin (~1mm) fibres for test moreover not know parameters of this fibres ● Price ? (Higher than for standard fibres) ● Non-uniformity of light in tiles (attenuation) ● Need to focus enough LED light into fibre (~100 more than present)
4
Dec 19, 2007Jan Smolik4 Side-emitting fibre Test: SLL600UVT from FiberTech - Germany (long-length side-emitting fibre)
5
Dec 19, 2007Jan Smolik5 Classical fibres ● Low costs – many suppliers ● Need additional modification to produce side light – remove cladding or to bend fibre (< minimum bending radius, curvature shape?) ● More complicated installation ● Need to focus enough LED light into fibre
6
Dec 19, 2007Jan Smolik6 Classical fibres Test: CK40 from Mitsubishi Rayon Corporation
7
Dec 19, 2007Jan Smolik7 Classical fibres “Processed” fibre – light emitting fibre end Bending rubbing
8
Dec 19, 2007Jan Smolik8 Conclusion ● Both fibres generate signal in tiles – from side- emitting is smaller – need to test a different type (getting short-length fibre) ● About to test new UV/Blue LEDs to get enough light ● For developing of system for new prototype of TileHCAL we need at least two tiles with SiPM detectors and readout electronics
Similar presentations
© 2024 SlidePlayer.com. Inc.
All rights reserved.