1. EXECUTES WORK TO PAINT Technological And Engineering

2. Teknologi dan Rekayasa Antecedent Work paints started by cleaning all dirts acting as isolator, for example : Iubricant, other dirt and pollutant. Surface of wood is emery with number emery 80 – 150. after cleanness hereinafter is done step finishing paint.

3. Teknologi dan Rekayasa Work paints :  Veneering of sealer at surface of wood with paintbrush, sealer called as paint meni, primary, or under coat. functioning Meni as adhesive power adder layer for painting the next phase.  After 3 – 4 hour, meni mongering would. To smooth down it hence meni is emery number 150.  Third phase is admission filling of wood pore and smooths down surface with plamuur application with skrap.

4. Teknologi dan Rekayasa  After 12 hours, surface of object has deflected emery number 180 – 240, to water down emery is applied lace or sits side by side block made from hard rubber.  Phase hereinafter is done painting between medias with priming alkid, priming alkid usually having colour white and applies solvent afdunner. After 4 – 5 hour priming to emery number may 240 – 320 by the way of wet.  Setting coat, be step finishing most importantly. Because this step would seen good and work obsolence finishing. At this setting coat paint alkid which has been determined the colour is dabbed with longituade latitude method.

5. Teknologi dan Rekayasa Works painting with system spray Initial step don't differ from paintbrush paint, work of spray only be done at elementary alkid paint and paint alkid end. To get good result, viscosity of paint must be paid attention. Doesn't paint too viscid, because if too jelled paint cannot be sprayed to surface of job object carefully.