1. ANSYS Workbench – Design Simulation Introduction
Training Manual
ANSYS Workbench – Design Simulation Introduction

2. Training Manual ANSYS Workbench – Design Simulation Introduction
Inventory Number:
First Edition
ANSYS Release: 8.0
Published Date: February 2, 2004
Registered Trademarks:
ANSYS® is a registered trademark of SAS IP Inc.
All other product names mentioned in this manual are trademarks or registered trademarks of their respective manufacturers.
Disclaimer Notice:
This document has been reviewed and approved in accordance with the ANSYS, Inc. Documentation Review and Approval Procedures. “This ANSYS Inc. software product (the Program) and program documentation (Documentation) are furnished by ANSYS, Inc. under an ANSYS Software License Agreement that contains provisions concerning non-disclosure, copying, length and nature of use, warranties, disclaimers and remedies, and other provisions. The Program and Documentation may be used or copied only in accordance with the terms of that License Agreement.”
Copyright © 2004 SAS IP, Inc.
Proprietary data. Unauthorized use, distribution, or duplication is prohibited.
All Rights Reserved.

3. ANSYS Workbench – Design Simulation Introduction Table of Contents
2. Design Simulation Basics 2-1
A. Launching Design Simulation 2-3
B. Startup Panel 2-14
C. Basic Procedure 2-18
D. Workshop – Design Simulation Basics 2-42
3. General Preprocessing 3-1
A. Geometry Branch 3-5
Contact 3-13
Meshing 3-29
D. Workshop – Mesh Control 3-52
4. Static Structural Analysis 4-1
A. Geometry 4-5
B. Assemblies – Solid Body Contact 4-8
Loads and Supports 4-20
Solution Options 4-39
Results and Postprocessing 4-46
F. Workshop – Linear Structural Analysis 4-62
5. Modal Analysis 5-1
A. Modal Analysis Procedure 5-6
B. Prestressed Modal Analysis 5-19
C. Workshop – Modal Analysis 5-26
6. Thermal Analysis 6-1
Geometry 6-6
Assemblies – Solid Body Contact 6-11
Loads 6-26
Solution Options 6-35
Results and Postprocessing 6-42
F. Workshop – Thermal Analysis 6-47
7. Linear Buckling Analysis 7-1
Basics of Linear Buckling 7-7
Buckling Analysis Procedure 7-11
C. Workshop – Linear Buckling 7-24
8. Shape Finder 8-1
A. Shape Optimization Procedure 8-5
B. Workshop – Shape Finder 8-18
9. Results Postprocessing 9-1
A. Viewing Results 9-3
Scoping Results 9-18
Exporting Results 9-21
Coordinate Systems 9-24
Solutions Combinations 9-28
Stress Singularities 9-32
Convergence 9-35
H. Workshop – Advanced Results Processing 9-45
10. CAD & Parameters 10-1
A. CAD Interoperability 10-3
B. Multiple Design Studies 10-28
C. Parameter Manager 10-39
F. Workshop – Parameter Manager 10-46
February 2, 2004
Inventory #002010
TOC-3