1. Ethernet Utilities & Software
SECTION 7 - Ethernet Utilities and Software
This section will give you a brief overview of the ESTeem troubleshooting procedures.

2. ESTeem Discovery Program
SECTION 7 - Ethernet Utilities and Software
Designed to configure regardless of IP address on computer
Will display 195E by Ethernet MAC address
Configures IP Address to 195E
Update Firmware
Open Web Browser to 195E
Computer must have IP address (DHCP connection or fixed IP address)
Designed to displaced connected ESTeem only
Troubleshooting
The first consideration is to verify that there is RS-232 communication.
Next is to verify the ESTeem commands are correct for the application that is being utilized.
Then the swr needs to be tested, start at the modem end first. If there is a bad reading on the swr, then attach the bird meter to the antenna end to verify if the cable is bad or the antenna is.
Then the signal strength needs to measured.
Finally conduct a polling diagnostic test.

3. Narrowband Utility Software
Imbedded in New Flash Discovery Utility
Used for programming Model 195C, 195H and 195M
Basic and advanced programming
Programming Software
Diagnostic Utility
Console Mode
Spectrum Analyzer
Diagnostics and Troubleshooting
Firmware Updates

4. ESTeem Network Configuration (ENC)
Network connections drag and drop
Visual Programming Software
Programming with ESTeems connected to switch
Programming one then another
On-Line or Off-Line Network Configurations
Firmware Updates
SSID
Frequency
Network Wide Changes

5. ESTeem EtherStation Status
ESTeem has no IP address
Only way to find status information from 195E
Only Functions in EtherStation Mode
Wireless MAC or Modem ID of Access Point
Receive signal strength
Will Display Current Connection Status
If configured for wrong connected computer MAC, utility will reprogram ESTeem to match
Will Change Programming of EtherStation 195E

6. Simple Network Management Protocol
SNMP
Universal computer network management protocol
High memory 195E required (195E – 2)
Wireless Network Management Items
Receive signal strength
RF data rate
Time of last update
Management Information Base (MIB)
Tables downloaded from ESTeem about menu
Complete list of MIB items available in manual

7. IGMP Snooping Global (UDP) Traffic On Wireless Bridge
Unicast packet created for each repeater peer
IGMP Snooping for Global Packet Steering
Repeater Peer Connections
Clients
Packet Encapsulation
IGMP Snooping on mobile devices
All Configured in Advanced Menu

8. VLAN Pass-through Virtual LAN (V-LAN) Traffic Unique Ethernet packet
Segmenting networks in data blocks
ESTeem 195E Will “Pass-Through” All VLAN Traffic
195E Does Not Function as VLAN Switch
Only two Ethernet ports available
Easier on network hardware

9. ESTeem Network Monitor (ENM)
Visual Interface for Network Monitoring
Receive signal strength
RF Data Rate
Networking routing in Mesh
Uses ENC Network Layout
Export ENC file
Discover new network
Uses SNMP MIB Table
195E series -2 only