1. Generators, Motors, and AC Power
Discuss AC and DC.
Discuss Inductance, Generators and Alternators.
Learn how transistors operate.
Drive a DC Motor using Pulsewidth Modulation.
EM41 - M.Nelson
NASA-Threads
Update: 7/24/2010

2. History of Electric Power Generation
DC power was made popular by Thomas Edison in the late nineteenth century.
Power could only be transmitted about one mile - electrical losses were too great.
In 1891, the London Electric Supply Corporation became the first modern power station, delivering AC power to residents of London.
George Westinghouse and Nikola Tesla
AC power can be transmitted much greater distances than DC power.
EM41 - M.Nelson
NASA-Threads

3. AC - DC
Magnitude
Time
EM41 - M.Nelson
NASA-Threads

4. Inductance
If you move a magnetic field near a wire or a coil of wire, you can create an electric current. This principle is called inductance.
Set your multimeter to 2VDC and attach it to the terminals of your small DC motor. Spin the rotor while holding the stator (the body of the motor). You should see a voltage measurement appear on the screen as long as you turn the rotor.
EM41 - M.Nelson
NASA-Threads

5. Generators and Alternators
When a motor like this is used to create an electric current it is called a generator because it generates electricity.
This is similar to the alternator in automobiles.
An alternator creates AC power, which is later converted to DC power for use in your car.
EM41 - M.Nelson
NASA-Threads

6. Controlling a DC Motor with a Microcontroller
Microcontroller can’t (typically) supply enough current to drive the motor directly.
(Power) Transistors are used to solve this problems.
A transistor can be switched “on” with a small amount of current to allow a larger amount of current to flow from a source.
EM41 - M.Nelson
NASA-Threads

7. Transistors Schematic Diagram for an NPN Transistor EM41 - M.Nelson
NASA-Threads

8. Pulsewidth Modulation (PWM)
Used to control motor speed.
By sending pulses to the a PWM circuit, we can control the “Duty Cycle” and therefore the power delivered.
Pulses are delivered to the motor fast enough that it maintains a constant speed (at some % of full power).
Time
Magnitude
100% - Full Speed
0% - Stop
EM41 - M.Nelson
NASA-Threads

9. PWM Circuit
EM41 - M.Nelson
NASA-Threads

10. PWM Command Pin Duty Cycle (0 – 255  0 – 100%) PWM 9, duty, 1
Duration (ms)
For this project, the duty variable is set to start at 132 because testing showed that for this setup, duty cycles below 132 did not produce any rotation of the motor.
EM41 - M.Nelson
NASA-Threads

11. Motor Control Project duty VAR Word counter VAR word time VAR Word
Main:
duty = 132
FOR counter = 0 TO 4 'Ramp to full power in 5 steps
duty = duty + 22
FOR time = 0 TO 'Pulse motor 500 times at
PWM 8, duty, 'current duty cycle.
next
GOTO Main
end
EM41 - M.Nelson
NASA-Threads

12. Assignment Finish circuit and run motor.
Change loop count as needed to clearly observe changes in motor RPM
EM41 - M.Nelson
NASA-Threads