2. Roof Insulation Adhesives: Garland’s Insul-Lock® II, Insul-Lock HR & Insul-Lock E HR Systems

3. Features & Benefits Ease of Installation No Deck Penetration
Insul-Lock II is a Single-Component, is Pourable and Requires No Equipment
Insul-Lock HR and Insul-Lock E HR are Self-Contained Two-Component and Mixed Through a Static Mixing Tip
No Deck Penetration
Reducing Structural Damage
Moisture Entry
Thermal Bridging
FM Approvals*
Approved with Garland Hot Asphalt, Weatherking®, Green-Lock® and Torch Systems, as an Insulation Adhesive
Low Odor
Insul-Lock II 50 g/l VOC Content
Insul-Lock HR 0 g/l VOC Content
Insul-Lock E HR 0 g/l VOC Content
*Approvals are specific to construction design and products contained in the assembly. Please contact your local Garland representative for project specific approvals.

4. Surface Preparation
The Surface Must be Clean, Sound, Dry, and Free of Any Materials That Would Inhibit Proper Adhesion of the Adhesive
The Use of Scraping, Power Brooming, Vacuuming or Other Means May Be Required To Achieve a Suitable Surface For the Application of the Adhesive
Cleaning Should Always Be Performed Observing Responsible Trade Practices

5. Application Rates Traditional Insul-Lock II Insul-Lock HR
Four 1/2” to 3/4” (1.27 – 1.91 cm) 12” o.c. Beads Must be Installed with 4’ x 4’ Boards
3 Gallon Bucket Totaling 450 sq. ft. (41.8 m2)
Insul-Lock HR
Four 1/4” to 1/2” (0.64 – 1.27 cm) 12” o.c. Beads Must be Installed with 4’ x 4’ Boards
4 Cartridges Per Case Totaling 600 sq.ft. (55.74m2)
See Application Guide for Perimeter and Corner Coverage Rates
Insul-Lock E HR
Application Note: Due to anticipated surface irregularities of a gravel surface roof, the application will require more adhesive than our standard rates. The standard rate is 600 sq.ft. case. Anticipated coverage rates will be in the range of 300 to 400 sq.ft. per case.

6. Insul-Lock II Benefits of Insul-Lock II Contractor Friendly Cures Fast
Can be Applied Directly From the Container
Easy to Pour Application
Cures Fast
Sets Up in Minutes
Versatile
Decks
Insulation
Base Sheets

7. Insul-Lock HR High Rise Foam Solvent-Free Ready to Use
Benefits of Insul-Lock HR
High Rise Foam
Accommodates Minor Surface Irregularities
Solvent-Free
VOC-Free and No Odor
Ready to Use
No Mixing Required
Applied Through Static Mixing Tip

8. Insul-Lock E HR Solvent-Free Ready to Use
Benefits of Insul-Lock E HR
45% Rapidly Renewable Material Content
USGBC Credits
Solvent-Free
VOC-Free and No Odor
Ready to Use
No Mixing Required
Applied Through Static Mixing Tip

9. Application Equipment

10. Summary
Insul-Lock II, Insul-Lock HR and Insul-Lock E HR are Either One Or Two-Component Urethane Foamable Insulation Adhesives
These Systems Provide a FM Approved Insulation Adhesive with Most Garland Roofing Systems
These Systems Can Eliminate Odor Concerns on the Jobsites