1. REPAIRING PANEL DOOR OR FENDER INSTALLING ADDITIONAL PERIPHERAL
BODY OTOMOTIF (F-022)
SK – KD 06

2. TARGET OF ACTIVITY LEARN
Educative participant can know additional components
Educative participant can know the way of additional peripheral
Teknologi dan Rekayasa

3. INSTALLING ENGINE HOOD1
Installing hood of cabin with installing right hasp before 2
Installing hood moulding 3
Installing channel of washer to hood 4
Installation of unlock cable pass house strut
Teknologi dan Rekayasa

4. BEHIND FENDER
Most of behind fender make one with inner bodi by welded system pengelasan
Target of welding is to prevent dirt will enter among external construction and especial bodi
Teknologi dan Rekayasa

5. INSTALLING BUMPER 1 Installing bumper filter 2
Installing bumper side extension sub Assembly 3
Intalling bumper sub assembly
Teknologi dan Rekayasa

6. INSTALLING WINDSHIELD GLASS
intall rubber glass to front glass, and by using screwdriver aid enter mine to rubber cavity..
Teknologi dan Rekayasa

7. INSTALLING WINDSHIELD GLASS
Length mine until tip of middle underside less 10 cm ( 3,94 inchi) after around paired by mine
Teknologi dan Rekayasa

8. INSTALLING WINDSHIELD GLASS
with helped some one from outside, hold front glass at the same time place to flange bodi and press glass into.
Pairing front glass with attractively tip of middle shares mine in middle front glass till glass rubber related to flange fully.
Teknologi dan Rekayasa

9. INSTALLING WINDSHIELD GLASS
Teknologi dan Rekayasa

10. INSTALLING WINDSHIELD GLASS
If glass have been attached at its place, knock glass from outside bodi with rubber hammer to become the glass enter into flange bodi about mm avoid glass rubber
Teknologi dan Rekayasa

11. INSTALLING WINDSHIELD GLASS
Cleaning glue of glass which remain, wait about 3 hour to know result of installation of banding possibility
Teknologi dan Rekayasa

12. INSTALLING SEAT
install bolts fastener out track seat and recliner
Tide all seat component
Install bolts fastener by shifting seat to the front and rear
Teknologi dan Rekayasa

13. INSTALLING INSTRUMENT PANEL1
Install instrument panel. 2
Install speedometer cable , air hoses 3
Install wiring instrument, ect fuse, radio and the other component 4
Install bolt fasterner of goods place drawer
Teknologi dan Rekayasa

14. INSTALLING INSTRUMENT PANEL5
Install bolts bracket heater 6
Install wheel steering and heater contol cable 7
Install choke control connector 8
Install negative terminal battery.
Teknologi dan Rekayasa

15. INSTALLING GRILL AND MOULDING
Straightening top table of moulding to vehicle bodi
Press downwards with use hand.
When installation moulding to glass weather strip can use soap water
Teknologi dan Rekayasa