1. Pump Fabrication Day Group A will draw their pump
Group B will make their pump

2. DISCLAIMER & USAGE
The content of this presentation is for informational purposes only and is intended for students attending Louisiana Tech University only.
The authors of this information do not make any claims as to the validity or accuracy of the information or methods presented.
Any procedures demonstrated here are potentially dangerous and could result in damage and injury.
Louisiana Tech University, its officers, employees, agents and volunteers, are not liable or responsible for any injuries, illness, damage or losses which may result from your using the materials or ideas, or from your performing the experiments or procedures depicted in this presentation.
The Living with the Lab logos should remain attached to each slide, and the work should be attributed to Louisiana Tech University.
If you do not agree, then please do not view this content.
boosting application-focused learning through student ownership of learning platforms

3. Other Parts & Pump Assembly
Group A: SolidWorks Modeling
Other Parts & Pump Assembly
Pump Body
Measure & draw a screw
Measure & draw a barbed fitting (don’t worry about screw threads & intricate details)
Measure & draw the motor
Complete your assembly in Solidworks
Faceplate
Impeller (your own design)

4. Group A: Robot Challenge
Work on the robot challenge after finishing the SolidWorks assembly (if time permits)
Solder photoresistors or complete other robot work
Work on programming (move a mat to your table)

5. Group B: Make Your Pump
Don’t start until you receive safety training from your instructor
Turn in signed safety quizzes after training
Follow directions on the PowerPoint presentation
If you are unsure of something, then ask for help