1. Task T6.2 Tertiary Buildings infrastructures installations
WP6 Pilot Set-up, Model Calibration and Assessment
Task T6.2 Tertiary Buildings infrastructures installations
CNet / CERTH

2. Overview Selected DEMO Pilot sites at CERTH ITI Building
Equipment Procurement / Installation Status per space
Sensor Integration to LS and Data Availability through IAM
Detailed presentation of equipment installation at DEMO Areas
Equipment Installed for DEMO at CERTH

3. CERTH Pilot areas selected for DEMO
Selected CERTH ITI Building areas:
1st Floor: Developer’s Office, Meeting Room, Corridor & Rest Area
Ground Floor: ITI Kitchen
ITI Building 1st Floor
ITI Building Ground Floor

4. Equipment Procurement / Installation Status per space
Developer’s Office
Meeting Room
Corridor & Rest Area
Kitchen
Add Dimmable Lights
Done -
Replace Lights Actuators No
Door Double-Beam Sensors
Installed
Indoor Luminance
Acoustic Sensors
External Temperature + Luminance
Installed at the South – West side of ITI’s Building.
RFID
First Trials
Pending
Water Heater
Refrigerator

5. Sensor Integration to LS and Data Availability through IAM
Pilot Installation (CERTH)
LS IoT Implement. (CNet)
Integration to LS – Mapping (CNet)
Data Stored in IAM (TUK)
HVAC Monitoring:
Status & Room Temp HVAC Control:
ON/OFF and Set Temp
OPC Server OK
Mapping Started – Pending NO
Lighting Monitoring & Control
EnOcean Actuators
NO – Integration Pending
HVAC & Light Energy Consumption
EnOcean Clamps
OK ( for the DEMO)
CO2 / Temp/Hum
OK [2]
OK [1] (Mapping Pending)
Indoor Luminance
OK [7]
OK [4] (Mapping Pending)
Outdoor Luminance/Temp/Humid

6. Sensor Integration / Data Availability Planning
Pilot Installation
IoT Implem. (CNet)
Integration to LS – Mapping (CNet)
Data Stored in IAM (TUK)
Occupancy Sensor Data (Kinect, PIR, Double Beams etc.) OK
OK?
Occupancy Extraction Events ( Occupancy /Prediction per Space)
Office & Home Appliances Monitoring & Control (PC Screens, printers, Microwave Ovens, etc.)
SmartPlugs [37]
OK [37]
OK [32] (Mapping Pending)

7. Developer’s Office – Occupancy Extraction
5 Kinect Cameras installed
Re-configured and tested 5 different topologies
Optimized Topology selected utilizes 5 Kinect Cameras (due to obstacles in the office)
Exact Number of Occupants for 4 sub-spaces

8. Developer’s Office – Occupancy Extraction
Motion Detectors
Passive Infrared Radars + Magnetic Traps (Alarm System integration)
Real Time Response Time
High Accuracy
Low cost solution
Used for RFID automated Control

9. Developer’s Office – Occupancy Extraction
Door Counters
Active Infrared Double-Beams
High Accuracy
Low Cost
Pressure Mats
Medium / Low Accuracy
Extremely Low Cost
Connected to Arduino – integrated to LS through MySQL
Provide Occupant’s Direction
Will be used to trigger RFID Control
Combination scenarios will further be tested to check accuracy gain compared to separate solutions

10. Developer’s Office – User Profiling – Energy Consumption
Smart-plugs monitoring & control + consumption measurement
HVAC monitoring + controls
Already installed on most office appliances
LS - OPC Implemented, Integration Pending
7 x PC Towers ( No Control )
Actual Temperature
8 x PC Monitors ( On/Off Control)
Set Temperature
1 x Printer (On/Off Control)
On/Off Status
Lighting monitoring + controls (Dimmable – EnOcean)
Replaced all Lights with Dimmable ones (to allow User Profiling scenarios to be tested)
Dimmable actuators installed
LS Integration Implemented
Validated both Read & Send Control Commands through LS
On/Off
Dimming Level

11. Developer’s Office – User Profiling – Energy Consumption
Wireless EnOcean Power Meters with Clamps installed for both HVAC & Lighting
Measurement of AC Current
Environmental
Temperature (through HVAC)
Each Thermal Zone returns the respective value
BACNet Protocol – OPC Server
3 Luminance Sensors Installed
Each Visual Zone is covered separately
Wireless EnOcean Sensors

12. Developer’s Office – Zones
Thermal Zones
Visual Zones
Occupancy Zones

13. Meeting Room – Occupancy Extraction
Motion Detectors
Door Counter
(Double-Beams)
CO2
Late Response Time
Environmental Disturbances
Acoustic Sensor
(connected to Arduino)

14. Meeting Room - User Profiling – Energy Consumption
HVAC monitoring + controls
Lights are measured by the EnOcean Actuators
LS - OPC Implemented, Integration Pending
HVAC consumption will be simulated through Models
Lighting monitoring + controls
(Controllable – EnOcean)
Hardware Installation Competed
LS Integration Implemented, Validation Pending
On/Off
Smart-plugs: Monitoring & Control + consumption Measurements
All Available Plugs (power-strips) covered – Group Based Measurements

15. Meeting Room - User Profiling – Energy Consumption
Environmental
Wireless EnOcean
Indoor: Temperature /Luminance
Outdoor: Temperature / Luminance/ Humidity
DEVELOPER’S OFFICE
MEETING ROOM
Luminance
Temp / Hum

16. Corridor & Rest Area - Occupancy
Motion
Detectors
Acoustic Sensor
(Connected to Arduino)

17. Corridor & Rest Area – User Profiling – Energy Consumption
Environmental
HVAC monitoring + controls
Temperature / Luminance (+ Motion)
LS implementation ok
Lighting monitoring + controls
Integration Pending
Hardware Installation Pending
(Not available for the Demo Pilot)
LS Integration & Validation Pending
Smart-plugs monitoring + control + consumption
SmartPlugs to all Office Appliances
Smart Water Heater Pending
Energy Consumption
No - Lights & HVAC will be simulated

18. Corridor & Rest Area - Zones
Thermal Zones
Visual Zones
Occupancy Zones

19. Kitchen – Occupancy Extraction
Kinect Cameras
Depth Image Utilization
Validated Real Time Occupancy Extraction
Optimized Topology for Occupants Exact Number
Acoustic sensor (connected to Arduino)

20. Kitchen - Occupancy Occupancy Extraction Motion Detectors
Door Counters
Active Infrared Beams
CO2 / Temp / Hum
Extract occupancy through appliances Usage
as received through Smart Plug monitoring)
Pending to be tested

21. Kitchen – User Profiling & Energy Consumption
HVAC monitoring + controls
Lights are measured by the EnOcean Actuators
Lighting monitoring + controls
HVAC will be simulated through DER models
(Controllable – EnOcean)
Hardware Installation Competed
LS Integration Implemented,
On/Off
Smart-plugs Monitoring & Control + Consumption measurement
All Home Appliances are Being Measured
LS Integration Implemented & Validated

22. Kitchen - Zones
Thermal Zones
Visual Zones
Occupancy Zones

23. RFID Deployment for DEMO
Initial trials with demo equipment
Installation pending
4 x Antennas
1 x 4-port Reader

24. Equipment Installed for DEMO at CERTH
Developer’s
Office
Corridor & Rest Area
Meeting Room
Kitchen
Total
Kinect 5 - 1 6
PIR 3
Active Infrared Double-Beams 4 2 8
Pressure Mats
Acoustic
CO2 / Temperature / Humidity
Indoor Luminance 7
Outdoor Luminance
Outdoor Temperature / Humidity
Smart-Plugs 16 28
Dimmers
Actuators
Indoor HVAC Cassettes ( Temp )

25. Questions & Discussion
Thank You !!!