1. ANSYS Meshing Application Introduction
Training Manual
ANSYS Meshing Application Introduction

2. Inventory Number: 002645 1st Edition ANSYS Release: 12.0
Published Date: April 28, 2009
Registered Trademarks:
ANSYS® is a registered trademark of SAS IP Inc.
All other product names mentioned in this manual are trademarks or registered trademarks of their respective manufacturers.
Disclaimer Notice:
This document has been reviewed and approved in accordance with the ANSYS, Inc. Documentation Review and Approval Procedures. “This ANSYS Inc. software product (the Program) and program documentation (Documentation) are furnished by ANSYS, Inc. under an ANSYS Software License Agreement that contains provisions concerning non-disclosure, copying, length and nature of use, warranties, disclaimers and remedies, and other provisions. The Program and Documentation may be used or copied only in accordance with the terms of that License Agreement.”
Copyright © 2009 SAS IP, Inc.
Proprietary data. Unauthorized use, distribution, or duplication is prohibited.
All Rights Reserved.

3. Course Contents Chapter 1: Introduction to Workbench
Chapter 2: Meshing Application Overview
Chapter 3: Meshing Methods for 3D Geometries
Chapter 4: Common Meshing Application Controls
Chapter 5: Tetrahedral Meshing
Chapter 6: Sweep Meshing
Chapter 7: Multizone Meshing
Chapter 8: Meshing 2D Geometries
Appendix A: Mesh Quality
Appendix B: CFX-Mesh

4. Course Schedule Chapter 2 Intro to Meshing 9:00-9:45
Workshop :45-10:00
Chapter 3 Meshing 10:00-10:30
Break :30-10:45
Workshop :45-11:15
Chapter 4 Common Controls 11:15-12:00
Lunch :00-13:00
Workshop 4.1 & Workshop :00-13:30
Chapter 5 Tet Meshing 13:30-13:50
Workshop 5.1 & Workshop :50-14:30
Chapter 6 Sweep 14:30-14:45
Workshop 6.1 & Workshop :45-15:15
Break :15-15:25
Chapter 7 Multizone 15:25-15:40
Workshop 7.1 & Workshop :40-16:10
Chapter 8 Surface Meshing 16:10-16:20
Workshop :20-16:40
Appendix Overview 16:40-17:00