Presentation is loading. Please wait.

Presentation is loading. Please wait.

FED Front Panel Hole Size Problem

Similar presentations


Presentation on theme: "FED Front Panel Hole Size Problem"— Presentation transcript:

1 FED Front Panel Hole Size Problem
The Front-panel Hole for the passage of the MPO Ribbon connectors appears to be slightly too small and not well centred on the the ARx module on the PCB In particular, there is not enough space to allow the barcode mounted on the connector to pass unhindered 2D Barcode 15 June 2004

2 Detail view with approx measurements
1.5-2mm 0-0.5mm 15 June 2004

3 Remedy It seems that the inputs in the middle of the board are worst affected Due to PCB bowing? Add at least 1mm to the left-hand side of the cut-out as seen looking at the front of the mounted panel. Move the centre of the cut-out by 0.5mm to the left as seen from the front. The Barcode will always be mounted on the same side of the connector, as shown in the photos 15 June 2004


Download ppt "FED Front Panel Hole Size Problem"

Similar presentations


Ads by Google