1. Making a Call
CISCO SX-10 TeleCart
Touch the touch-Screen to awake from sleep. If it’s completely off, hold down the main power switch until unit starts up
Touch the dial-pad icon to bring up the dialling pad
Type the meeting number from the /invite, usually an “03xxxxxxxx” number. (Ignore and everything after it, enter only the number)
Press the “Call” button
Once the call is connected, enter the pin number from the invite, followed by the # Hash key
If no one else has joined the Video Conference, you should see a message “You are the only call in this conference”, otherwise you should see the far-end participants
Camera
Monitor
Touch-Screen
Height Adjust
Wheel Lock
Power-switch behind monitor
Problems?
Please call the CAAC Helpdesk on: (08) or

2. During a Call / Ending the Call
During the call you can control the camera movement and zoom level
Touch the Camera Icon to bring up the move/zoom panel
Use the arrows to move the camera and the + and – to Zoom
Tick the “Selfview” box to see how you and your patient is centred in the picture. (Use this to ensure the far-side clinician can see the patient clearly)
Touch the “End” button to hang-up the call when finished
The cart will go into “Sleep Mode” on it’s own after some time
Use the Speaker volume up/down keys and the “Microphone Mute” on the touch-screen as required
Problems?
Please call the CAAC Helpdesk on: (08) or
An editable version of this doc is available to all at:
This file “