1. Grohe Blue® Settings of the electronics

2. Settings of the electronics
Grohe Blue® Starter Kit Grohe Blue® with Cooler
The settings are programmed by finger tap on the LED‘S
Setting for the installer
Only for Grohe Blue Starter Kit
Adjustment of the water flow:
Touch both LED‘s for 5 till 7 seconds.
Confirmed by light up from both LED‘s and the handle (red).
Open the handle and fill the carafe and close the handle.
With double click on the red LED you confirm the settings.
Confirmation of the settings, both LED‘s are flashing.

3. Settings of the electronics
Setting for the installer
Setting of the filter cartridges:
Keep your finger on the green LED for 5 till 7 seconds.
The green LED flash: 1x for Liter x for 1500 Liter x for 3000 Liter
Confirmation of the settings, double click on the green LED (after the desired setting)
Confirmation by the green LED, (flashing 4 X)
The desired settings will be confirmed by the green LED (example. 2 x for 1500 ltr.) .
4x Flashing
2x Flashing

4. Settings of the electronics
Setting for the installer
Setting of the Water hardness:
Double click on the green LED.
The green LED flashes 4 X
Again double click on the green LED
After the first flashing of the red LED, double click on the red LED.
The green LED flash 1x for die KH° x for die KH° x for die KH° x for die KH° x for die KH° x for die KH° 07-09
Confirm your settings by double click on the green LED.
Your desired settings will be confirmed by flashing from the green LED (4 X) and will by confirmed again from the green LED (your settings)
4x flashing
1-6x flashing

5. Settings of the electronics
Setting for the installer
Factory settings:
Double click on the green LED.
The green LED flashed 4 X
After the 4 flash again double click on the green LED.
After the third flashing of the red LED, double click on the red LED.
Confirm your settings by double click on the red LED.
Your desired settings will be confirmed by flashing from the green LED (4 X)
4x flashing
3x flashing
4x Flashing

6. Settings of the electronics
Setting for the installer and costumers
Settings after replacement of the filters:
Keep your finger on the red LED for 5 till 7 seconds.
The red LED lights up.
Confirm your settings by double click on the red LED.
Your desired settings will be confirmed by flashing from the red LED (3 X)
3x flashing