Download presentation
Presentation is loading. Please wait.
Published byAlexander Whitehead Modified over 6 years ago
1
What is a DAC? A digital to analog converter (DAC) converts a digital signal to an analog voltage or current output. DAC
2
Types of DACs 1.Binary Weighted Resistor:-
Many types of DACs available. Usually switches, resistors, and op-amps used to implement conversion Two Types: Binary Weighted Resistor. 2. R-2R Ladder. 1.Binary Weighted Resistor:- Utilizes a summing op-amp circuit Weighted resistors are used to distinguish each bit from the most significant to the least significant Transistors are used to switch between Vref and ground (bit high or low)
3
Binary Weighted Resistor
- + R 2R 4R 2nR Rf Vout I Vref Assume Ideal Op-amp No current into op-amp Virtual ground at inverting input Vout= -Irf
4
Binary Weighted Resistor
- + R 2R 4R 2n-1R Rf Vout Vref V1 V2 V3 Vn Voltages V1 through Vn are either Vref if corresponding bit is high or ground if corresponding bit is low V1 is most significant bit Vn is least significant bit msb If Rf=R/2 msb For example, a 4-Bit converter yields Where b3 corresponds to Bit-3, b2 to Bit-2, etc.
5
Binary Weighted Resistor
Advantages Simple Construction/Analysis Fast Conversion Disadvantages Requires large range of resistors (2000:1 for 12-bit DAC) with necessary high precision for low resistors Requires low switch resistances in transistors Can be expensive. Therefore, usually limited to 8-bit resolution.
6
2R-2R Ladder DAC Each bit corresponds Vref to a switch:
If the bit is high, the corresponding switch is connected to the inverting input of the op-amp. If the bit is low, the corresponding switch is connected to ground. Vref Bit: Vout 4-Bit Converter
7
R-2R Ladder 2R V3 Vref V2 V1 V3 Ideal Op-amp
8
R-2R Ladder V2 V3 R Vref V2 V1 V3 Vout I Likewise,
9
R-2R Ladder Results: Vref V2 V1 V3 Where b3 corresponds to bit 3,
b2 to bit 2, etc. If bit n is set, bn=1 If bit n is clear, bn=0 Vout
10
R-2R Ladder For a 4-Bit R-2R Ladder
For general n-Bit R-2R Ladder or Binary Weighted Resister DAC
11
R-2R Ladder Specifications of DACs Advantages Disadvantage Resolution
Only two resistor values (R and 2R) Does not require high precision resistors Disadvantage Lower conversion speed than binary weighted DAC Specifications of DACs Resolution Speed Linearity Settling Time Reference Voltages Errors
Similar presentations
© 2024 SlidePlayer.com. Inc.
All rights reserved.