1. TOOL IDENTIFICATION

3. BACK SAW
Has a heavy metal band on the back edge to help keep the blade stiff, and is used where fine and accurate cuts are required.

4. COMBINATION SQUARE
Has an adjustable head and blade, and is used for testing, measuring and marking 45 degree and 90 degree angles and lines.

5. COPING SAW
Used for cutting curves and intricate designs and has a very thin blade.

6. FILE CARD
A brush with metal and nylon bristles, use to clean files and rasps.

8. HAND DRILL
Can be manual, cordless or corded. Used with various types of drilling bits.

9. SCRATCH AWL
Used for marking the centers of holes to be drilled, or for starting screws.

10. TAPE MEASURE
Used for measuring long distance between 6’ and 100’

11. TRY SQUARE
The most common used square in the shop has a 200mm blade and can be used for testing, measuring, and marking 90 degree angles and lines.

12. TWIST BIT
Common sizes 1/64” to 1/2”, Spiral cylindrical object with a 59 degree tip on one end.

13. MALLET
Looks somewhat like a hammer but the head is made of softer material– wood, rubber or rawhide.

14. PENCIL
The most often used marking tool in the shop.

15. BENCH RULE
Used for measuring short distances, or can be used as a straight edge.

16. CHISEL
Straight edged cutting tool with a sharp beveled edge.

17. CARPENTERS SQUARE
Is used by carpenters in building houses and is the largest square.

18. 5-7 TEETH PER INCH
RIP SAW
Used for cutting with the grain and has between 5 to 7 teeth per inch.

19. 8-12 TEETH PER INCH
CROSSCUT SAW
Use for cutting across the grain and has between 8 to 12 teeth per inch.

20. HACKSAW
Used for cutting metal like screws and nails.

21. BLOCK PLANE
The Smallest hand plane, used primarily on end grains.

22. RASP
Metal forming tool that looks like a file but has a coarser cutting surface.

23. FILE
Metal forming tool that has grooves cut into its surfaces. Common shapes are flat, half round and round.

24. WHAT TOOL IS THIS?????

25. A COCONUT OPENER UPPER

27. CLAW HAMMER
Come in various sizes - 7oz, 13oz, 22oz, and has a forged head to hammer in nails and a curved claw for extracting nails