Download presentation
Presentation is loading. Please wait.
1
UNIT-II TURNING MACHINES
TAPER TURNING METHODS PREPARED BY SOUNDHAR.A
2
Taper Turning Taper - Uniform change in diameter along the length of work piece Taper turning - Operation of producing conical surface on cylindrical work piece Taper specified by conicity (K) – ratio of difference in diameters of taper to its length K = D – d l
3
Taper Turning - Methods
Form tool method Tail stock method Compound rest method Taper turning attachment method D - d l D d α Conicity K = _____ l D – Large diameter of taper d – small diameter of taper l – length of taper α - Half taper angle
4
Form Tool Method Short taper Form tool ground to required angle
Tool fed perpendicular to lathe axis Operation slow speed Work Piece Form tool
5
Tail Stock Set Over Method
Small tapers (> 8º)on long work pieces Work piece - b/w centers Line centre i.e. tail stock is off-set to a distance set over Axis of work piece turned to an angle from lathe axis Tool fed over rotating work piece parallel to lathe axis Then taper is made on work piece Contd..
6
Tail Stock Set Over Method
B C D l S α Set over h = ______ x L = L tan α D - d If the job is turned to its full length, l = L 2l D - d Set over h = ______ 2
7
Compound Rest Method Work piece held in chuck – rotated
Compound rest – swiveled to required angle – clamped Angle tan α = D – d 2l Tool fed by compound rest hand wheel D l α
8
Taper Turning Attachment Method
Arrangement Taper turning operation Attached - rear end of bed using bottom plate or bracket Swinging guide bar set to required angle - swiveled to a max of 100 Guide block moves on guide bar & connects rear end of the cross slide Cross slide made to move along the guide block by removing the binder screw
9
Taper Turning Attachment Method
Operation Work piece held b/w centers or in a chuck Guide bar turned to a required angle Longitudinal feed - tool Tool moves in angular way Depth of cut given by turning the hand wheel of compound rest
10
Taper Turning Attachment Method
Angle of taper Binder screw Guide rail Job Tool Dead centre Cross slide Compound rest Cross feed hand wheel
11
Lathe Attachment Milling attachment Copying attachment
Grinding attachment Taper turning attachment
12
Grinding Attachment Attached to cross slide
Work piece & grinding wheel rotate External grinding Work piece – b/w centers - & rotated Internal grinding Work piece – chuck & rotated Feed – moving carriage Depth – moving cross slide
13
Grinding Attachment Work Belt drive Head stock Chuck Grinder spindle
14
Milling Attachment 1st method 2nd method
Milling cutter – chuck – rotated Work piece – cross slide Work fed against rotating milling cutter Depth – vertical adjustment of work piece Used to cut key ways & grooves 2nd method Milling mounted on carriage Work piece – held b/w centers – not rotated Cutter driven by motor vertically Feed given by carriage
15
Milling Attachment Vertical slide Clamping screw Packing piece
Swivel base Cross slide Chuck End mill Work Carriage Bed
Similar presentations
