1. Practical Exercise One
Accessing TRIM
Practical Exercise One
Please begin on next page 1

2. Accessing TRIM
Access TRIM from any NMCI Seat: Click on : Start  Select All Programs  Select HP TRIM folder (Ensure you select HP TRIM instead of HP TRIM Desktop)  Select HP TRIM Continue to next page…
Ensure HP TRIM Vice HP TRIM Desktop 2

3. Accessing TRIM – Default Dataset
Highlight each Dataset Name and click on REMOVE button, this gives you a clean slate to start from
Next click Add to select preferred dataset 3

4. Accessing TRIM – Default Dataset
Type in TRIMPRIMARY (this is our preferred server)
The port is 1137
Click Next 4

5. Accessing TRIM – Default Dataset
Highlight the Bureau of Naval Personnel dataset >
Click Finish > NOTE: Click CANCEL if Bureau of Naval Personnel is not shown in window
Check out the Check Mark!!!
Note “Check” field 5

6. Accessing TRIM – Default Dataset
Click on Properties
Type “TRIMsecondary”
Port should be 1137
Click OK 1 2 3 6

7. Accessing TRIM – Default Dataset
Highlight Bureau of Naval Personnel (your dataset)
Ensure this box is checked
Click the Default button to make it your default dataset.
When you open TRIM, it should automatically connect to your dataset. Continue on next page… 7

8. Accessing TRIM – Default Dataset
Click OK
NOTE:
Settings are workstation-specific. If you log in from a different NMCI workstation, you will need to set up your default dataset again. 8

9. Now you’ve done it…You’re in TRIM…
You can click close on the tip of the day dialog box, but you can really learn a lot about TRIM from the daily tips!

10. Command Default Settings “Get Global”
Go to “Tools”
Select Options
Click “Get Global” (button at bottom of the dialog box) 1
Click OK 3
Click OK 2
End of exercise
Any Questions??? 10