1. PLC Millenium II
Application Notes
NEUSS November 2004

2. Waste Water Filtration System
Millenium used to monitor floats, turn on pumps, and control alarms in septic systems.
1) Pretreatment Tank
2) Aeration Chamber
3) Clarifier Chamber
4) Chlorinator
5) Holding Tank
6) Aerator Pump
7) Millenium Control Center
8) Discharge Pump

3. Waste Water Program

4. Landscape Irrigation & Water Fountain Controller
The Millenium monitors float switches, turns on pumps, provides time-of-day control for fountain operation, monitors wind speed on outside fountains, and controls fountain lighting

5. Irrigation and Fountain Program

6. Packaging Equipment
The Millenium controls feeder mechanisms, monitors temperature, controls sealing devices, and maintains count of products being sealed and total sealed packages

7. Millennium 2 monitors bag sensing and indexing, the blower to inflate bags, the sealing bar, counts and displays the number of operations.
Bag indexing is adjustable to the size of the bag.
A bag rolled out on the plan. A blower is then turned on to inflate the bag so pieces can be dropped into it.
Once the bag is full, a sealing bar tilts down seals the the top of it.
If an object interferes while the bar is tilting down switches will sense it a forbid the complete tilting.

8. Conveyors
The Millenium controls motors, counts product, detects belt jams (alarm condition), controls sorters, provides time-of-day start/stop schedule, controls lubricating system

9. Conveyor Program

10. Dock Leveler
The Millenium monitors the up/down control buttons, detects the upper/lower limits, controls the dock-lip, provides automatic time-out, provides status/error messages

11. Dock Leveler Program

12. Access Control & Security
The Millenium monitors card reader or key pad, controls locking mechanisms, controls motor for door/gate/barrier, monitors limit switches, monitors access time, controls status lights

13. Security Gate Program

14. HVAC & Refrigeration
The Millenium monitors indoor/outdoor temperatures, measures humidity, controls compressors, blowers, dampers, and fans, controls lighting relative to ambient and/or time-of-day

15. HVAC&R Program

16. Lighting
The Millenium controls indoor lighting based on time-of-day, and/or outdoor lighting based on ambient light levels

17. Interior lighting will be controlled via a time switch function block programmed to normal business hours. Gas Pump Lighting will be controlled via the interior lighting time switch and a photo-sensor. The time switch will give a signal during normal business hours. The photo-sensor will give a signal indicating darkness. An AND function block will take both the signals and turn on the appropriate output. Sign Lighting will be controlled via the photo-sensor. During all dark hours the sign will be lit. A switch will be provided to operate sign lights only during dark business hours. A motion sensor in the stock room will be monitored to only turn on lights when an employee has entered the room.

18. Trash Compactors
The Millenium monitors the start button, powers the motors, monitors limit switches, provides timing function, and controls lighting indicators and alarms

19. When the start button is pushed , an alarm (O3) will sound for 3 seconds. The motor (O1) will then start.
If the auxiliary contacts are not activated within a short set time, it will trigger the light O2 signaling something wrong.
The timers are set back to initial value and are ready for the next cycle.
An emergency stops button is wired to Input 4 and would stop the process if pressed.