1. D-Series Custom App Installation
Philips Signage

2. Prepare USB Copy your “.apk” file to the root of a USB flashdrive
Note: Supported valid file formats are FAT, FAT32, EXT3, and EXT4

3. Insert the USB
The USB Flashdrive must be installed into the USB Data port – which is the rearmost port – closer to the back cover. (The other port is power only) (normally covered.)

4. Enter Android Menu Press Home 1888 – 1 – 8 – 8 – 8
to enter the Android menu
Select Apps
Then select File Manager
File Manager

5. Select “mnt”
Then select Open
mnt
mnt
Open

6. Select “usb_storage”
Then select Open
usb_storage
usb_storage
Open

7. Select your .apk file
Then select Open
Open

8. Scroll down and select Done Scroll down to accept permissions
When done,
Scroll down and select Done
Scroll down to
accept permissions
Then select Install
Install
Done

9. Now that your app is installed:
If you want this app to be your default content at turn-on, there are two additional steps you must perform:
Set this app as the “Custom input source”
Set the “Custom input source” as the “Boot-on source”

10. 1. Set the Custom Input Source
Enter Android Menu: Press Home 1888 on the RC
– 1 – 8 – 8 – 8
to enter the Android menu
Select Settings

11. Select “Signage Display”

12. Select “Custom app”
Signage Display
Custom app

13. Select “Select app” This will pop up a list of installed apps
Select the app you want to assign to the “Custom” input source
Save
Then Select “Save”

14. Exit the Android menu
Press the Back button (O) several times until the Android menu is exited completely

15. 2. Set the “Boot on source”
Enter the Scaler menu
Press the Home ( ) button on the remote control

16. Set Configuration 1 / Boot on source to Custom
Scroll down to “Configuration 1”
Scroll right and down to “Boot on source” and select it
Scroll right or left to select input “Custom”
Done!