1. Estimating the Value of a Parameter Using Confidence Intervals
Chapter 9
Estimating the Value of a Parameter Using Confidence Intervals

2. Section
9.2
Confidence Intervals about a Population Mean When the Population Standard Deviation is Unknown

3. Objectives Know the properties of Student’s t-distribution
2. Determine t-values
3. Construct and interpret a confidence interval for a population mean

4. Objective 1
Know the Properties of Student’s
t-Distribution

5. Student’s t-Distribution
Suppose that a simple random sample of size n is taken from a population. If the population from which the sample is drawn follows a normal distribution, the distribution of
follows Student’s t-distribution with n-1 degrees of freedom where is the sample mean and s is the sample standard deviation.

6. Compute and for each sample.
Parallel Example 1: Comparing the Standard Normal Distribution to the t-Distribution Using Simulation
Obtain 1,000 simple random samples of size n=5 from a normal population with =50 and =10.
Determine the sample mean and sample standard deviation for each of the samples.
Compute and for each sample.
Draw a histogram for both z and t.

7. Histogram for z

8. Histogram for t

9. CONCLUSIONS:
The histogram for z is symmetric and bell-shaped with the center of the distribution at 0 and virtually all the rectangles between -3 and 3. In other words, z follows a standard normal distribution.
The histogram for t is also symmetric and bell-shaped with the center of the distribution at 0, but the distribution of t has longer tails (i.e., t is more dispersed), so it is unlikely that t follows a standard normal distribution. The additional spread in the distribution of t can be attributed to the fact that we use s to find t instead of . Because the sample standard deviation is itself a random variable (rather than a constant such as ), we have more dispersion in the distribution of t.

10. Properties of the t-Distribution
The t-distribution is different for different degrees of freedom.
The t-distribution is centered at 0 and is symmetric about 0.
The area under the curve is 1. The area under the curve to the right of 0 equals the area under the curve to the left of 0 equals 1/2.
As t increases without bound, the graph approaches, but never equals, zero. As t decreases without bound, the graph approaches, but never equals, zero.

11. Properties of the t-Distribution
The area in the tails of the t-distribution is a little greater than the area in the tails of the standard normal distribution, because we are using s as an estimate of , thereby introducing further variability into the t- statistic.
As the sample size n increases, the density curve of t gets closer to the standard normal density curve. This result occurs because, as the sample size n increases, the values of s get closer to the values of , by the Law of Large Numbers.

13. Objective 2
Determine t-Values

15. Parallel Example 2: Finding t-values
Find the t-value such that the area under the t-distribution to the right of the t-value is 0.2 assuming 10 degrees of freedom. That is, find t0.20 with 10 degrees of freedom.

16. Solution The figure to the left shows the graph of the
t-distribution with 10
degrees of freedom.
The unknown value of t is labeled, and the area under the curve to the right of t is shaded. The value of t0.20 with 10 degrees of freedom is

17. Objective 3
Construct and Interpret a Confidence Interval for a Population Mean

18. Constructing a (1-)100% Confidence Interval for ,  Unknown
Suppose that a simple random sample of size n is taken from a population with unknown mean  and unknown standard deviation . A (1-)100% confidence interval for  is given by
Lower Upper
bound: bound:
Note: The interval is exact when the population is normally distributed. It is approximately correct for nonnormal populations, provided that n is large enough.

19. Construct a 95% confidence interval for the bacteria count.
Parallel Example 3: Constructing a Confidence Interval about a Population Mean
The pasteurization process reduces the amount of bacteria found in dairy products, such as milk. The following data represent the counts of bacteria in pasteurized milk (in CFU/mL) for a random sample of 12 pasteurized glasses of milk. Data courtesy of Dr. Michael Lee, Professor, Joliet Junior College.
Construct a 95% confidence interval for the bacteria count.

20. NOTE: Each observation is in tens of thousand. So, 9. 06 represents 9
NOTE: Each observation is in tens of thousand So, 9.06 represents 9.06 x 104.

21. Solution: Checking Normality and Existence of Outliers
Normal Probability Plot for CFU/ml

22. Solution: Checking Normality and Existence of Outliers
Boxplot of CFU/mL

23. Lower
bound:
Upper
The 95% confidence interval for the mean bacteria
count in pasteurized milk is (3.52, 9.30).

24. Parallel Example 5: The Effect of Outliers
Suppose a student miscalculated the amount of bacteria and recorded a result of 2.3 x We would include this value in the data set as 23.0.
What effect does this additional observation have on the 95% confidence interval?

25. Solution: Checking Normality and Existence of Outliers
Boxplot of CFU/mL

26. Solution Lower bound: Upper
The 95% confidence interval for the mean bacteria
count in pasteurized milk, including the outlier
is (3.86, 11.52).

27. CONCLUSIONS:
With the outlier, the sample mean is larger because the sample mean is not resistant
With the outlier, the sample standard deviation is larger because the sample standard deviation is not resistant
Without the outlier, the width of the interval decreased from 7.66 to 5.78. s
95% CI
Without
Outlier
6.41
4.55
(3.52, 9.30)
With
7.69
6.34
(3.86, 11.52)