1. CLOSED-NOTES QUIZ: 5 MINUTES
U1-L10
September 10, 2007
CLOSED-NOTES QUIZ: 5 MINUTES
Take out a clean sheet of notebook paper and title it.
How many views are typically used when presenting technical drawings to a manufacturer?
Is that number of views sufficient to correctly manufacture an object as the designer intended?
The prefix “ortho” generally means what?
Sketch the TOP view of the object to the left.
Sketch the FRONT view of the object to the right.

2. U1-L10
QUIZ REVIEW
How many views are typically used when presenting technical drawings to a manufacturer?
3 Views: Top, Front, Right Side
Is that number of views sufficient to correctly manufacture an object as the designer intended?
Yes
The prefix “ortho” generally means what?
Straight

3. U1-L10

4. U1-L10

5. U1-L10
DRILL CHECK
Working with 1 or two partners, check your answers to numbers 1-4 on the Project 1 worksheet.
You have 1 minute.

6. U1-L10
DRILL CHECK
Working with 1 or two partners, check your answers to numbers 1-4 on the Project 1 worksheet.
You have 1 minute.

7. U1-L10
DRILL CHECK 5”
TOP
1.5”
1.5”
1 7/8”
FRONT
RT SIDE
1.5”
1 3/4”

8. U1-L10
1 7/8”
1 3/4”

9. HOT GLUE Hot glue station
U1-L10
HOT GLUE
Hot glue station
Size of a dime, squeeze together for ~30 seconds
Begin step 7

10. Butt one edge into the other
U1-L10
Butt one edge into the other

11. BAND SAW - Safety SAFETY GOGGLES REQUIRED (consequences if not worn)
U1-L10
BAND SAW - Safety
SAFETY GOGGLES REQUIRED (consequences if not worn)
Give each other at least 3’ of work space
Complete attention directed to work
Fingers no closer than 2”
Guard ~¼” above stock
Turn off IMMEDIATELY after use
Teacher consent prior to each use

12. BEFORE YOU CUT CHORES 10-minute bell is a signal to start wrapping up.
U1-L10
BEFORE YOU CUT
CHORES
10-minute bell is a signal to start wrapping up.
YOU ARE RESPONSIBLE FOR COMPLETING ON TIME, CLEANING UP, GETTING TO YOUR NEXT CLASS ON TIME.
Locker assignments

13. U1-L10
CLASSWORK/HOMEWORK
Sketch the 3 views (top, front, and right side) of the object you manufactured in class today. This will complete the Project 1 worksheet.
If you have not yet brought in a lock, bring one on Wednesday.

14. BAND SAW - DEMONSTRATION
U1-L10
BAND SAW - DEMONSTRATION