1. Teknologi Dan Rekayasa
LINES PLAN

2. PRINCIPAL DIMENTION
Teknologi dan Rekayasa

3. BASIC DEFINITONS AND SHIP GEOMETRY
Hull: The structural body of a ship including shell plating,
framing, decks and bulkheads.
Afterbody : That portion of a ship’s hull abaft midships.
Forebody: That portion of a ship’s hull forward midships.
Bow : The forward of the ship
Stern : The after end of the ship
Port :The left side of the ship when looking forward
Starboard : The right side of the ship when looking forward
Design Waterline (DWL) or Load Waterline (LWL) : The waterline at which the ship will float when loaded to its designed draught.
Moulded Surface : The inside surface of the skin, or plating, of a ship.
Forward Perpendicular (FP) : The vertical line at the point of intersection of the LWL and the forward end of the immersed part of the ship’s hull.
After Perpendicular (AP) : The vertical line at the point of intersection of the LWL and the centerline of the rudderstock.
Midships : The point midway between the forward and after perpendiculars.

4. SHEER STANDAR PLANT
Teknologi dan Rekayasa

5. SHEER STANDART PLAN
Teknologi dan Rekayasa

6. SHEER STANDART ( CONTINUE )
Teknologi dan Rekayasa

7. HALF BREADTH PLAN
Teknologi dan Rekayasa

8. DEFINITONS AND SHIP GEOMETRY
Deck Camber : The rise of the deck of the ship in going from the side to the centre. In older ships the camber curve used to be parabolic but in modern ships straight line camber curves are used or there may be no camber at all on decks.
Bilge Radius : The radius of the circular arc forming the bilge.
Flat of Keel (Half Siding) : The width of flat bottom plating on each side of the centre girder.
Deadrise (Rise of Floor) : The amount by which the line of the outer bottom plating amidships rises above the baseline. Therefore, it is the difference in height between the baseline and the point where the straight line through the bottom flat surface intersects the vertical line through the side of the moulded surface at its widest point.
Tumblehome : The amount the top of the side shell slopes back toward the centerline between the point of widest breadth and the deck at side
Parallel Middle Body : The portion of the ship over which the midship section remains unchanged. In this part of the ship water lines and buttocks have no curvature; that is, all the fore and aft lines are

9. Representing the Hull Form

10. THE HULL FORM ( CONTINUE )
Teknologi dan Rekayasa

11. The Body Plan
Teknologi dan Rekayasa

12. The Body Plan ( Continue )
Teknologi dan Rekayasa

13. Water and Buttocks
Teknologi dan Rekayasa

14. The Half-Breadth Plan
Teknologi dan Rekayasa

15. The Sheer Plan
Teknologi dan Rekayasa

16. CAMBER PLAN
Teknologi dan Rekayasa

17. CAMBER ( CONTINUE )
Teknologi dan Rekayasa

18. SENT
SENT
Teknologi dan Rekayasa

19. BUTTOCK LINE
Teknologi dan Rekayasa

20. HALF BREADTH PLAN
Teknologi dan Rekayasa

21. AFTER PLANT
Teknologi dan Rekayasa

22. FORE PLANT
Teknologi dan Rekayasa

23. LINES PLAN DRAWING
Teknologi dan Rekayasa

24. LINES PLAN DRAWING
Teknologi dan Rekayasa

25. The End