1. Smart Thermostat RDS 110 How to download and install the demo app (pre-version – Android only)
Restricted © Siemens AG 2017
siemens.com/buildingtechnologies

2. Where to get the demo app for the Smart Thermostat RDS110
If you would like to install the demo app, please contact: Hans Hüppi (mail: Guido Antonini (mail: or Marina Bacevic

3. Where to get the demo app for the Smart Thermostat RDS110
You will receive an . Please open the on your mobile and click on „click here“.

4. How to download the demo app
Please click on „download“. The download could take a few minutes.

5. How to install the demo app
You will see the demo app in your Downloads folder. Please click on „android-amv7-release.apk“. It may be that your mobile does not allow to install the app immediately due to security settings on your phone. If so, please click on Settings.

6. How to install the demo app
Please set the corresponding check mark and approve the installation again with „OK“.

7. How to install the demo app
The demo app will be installed after your approval. When finished you can open the app by clicking the “Thermostat” icon on your mobile.

8. How to use the demo app
In this demo version you can use ANY adress and password!
For example:
Password: Siemens
NOTE:
All settings are not persistent! Any modification will be overridden by default values on next start.

9. How to use the demo app
You now are logged in and can play with the demo app.
Please be aware that this demo pre-version is not fully developed yet! What can be shown:
Opening screen:
Change the temperature set point with the slider
Operating the red leaf (changes to green)
Change “at home” – “Away”
Change mode – Auto / Manual (red hand)
Next screen: Fan
Switch between “Auto” and “on”
Next screen: Hot water
Switch between Mode “Auto/Manual” and On/Off

10. How to use the demo app
Demo User selection screen (top left - 3 lines):
Several settings concerning Locations, Account and Devices can be made. Note that some settings cannot be selected in this version.
Settings (top right – gear wheel):
Modify the pre-settings for different states.
Create scheduler entries for thermostat and hot water.
Create entries by hold your finger on the screen. Modify by clicking on the new entry.