1. Basic router configuration
Click on the Config mode tab of Router0 to begin configuring the device.
After the device has finished booting, change the display name of the router to Zayton1. Changing the display name does not affect the configuration.
Click in the Hostname field and type Zayton1, then press the TAB key. Note the equivalent IOS command is entered in the lower portion of the window.
Click on interface FastEthernet 0/0 and assign the IP address , then press the TAB key. Enter the subnet mask

2. 5. Click the Port Status to On to enable the port (no shutdown

3. 6. To copy another router, make sure that the existing router is selected (it will be grayed out). In the Main Tool Bar click on the Copy tool.
7. Click on the Paste tool and the copied device will appear in the work area, and drag the new device to the desired location
8. Click on the Network Component Box and select Connections. Then select the Serial DCE connection .
9. Click on the Zayton1 router and connect to the Serial 0/0/0 interface.
Click on the new router (copy Zayton1) and connect to the Serial 0/0/0 interface.

4. 11. Click on the Zayton1 router and select the Config mode.
12) Select interface Serial 0/0/0.
13. Configure the interface Serial 0/0/0 with the IP address , then press the TAB key and enter the subnet mask on the interface.
14. Set the clock rate to
15. Click the Port Status to On to enable the port (no shutdown).
16. Click on the new router and select the Config mode.
17. Change the Display Name and Hostname to Zayton2.
18. Configure the interface Serial 0/0/0 with the IP address , then press the TAB key and enter the subnet mask on the interface.
19. Click the Port Status to On to enable the port (no shutdown).
NOTE: The link lights on the serial link should change from red to green to indicate the link is active.

5. Configure the routing protocol
Click on the Zayton1 router and select the Config tab. Then click on RIP and add the network address and
2. Click on the Zayton2 router and select the Config tab. Then click on RIP and add the network address
Go to each PC and set the Default Gateway to
Set the default gateway on the PCs
Click on PC-A and select the Config tab. Enter the default gateway address
Click on PC-B and select the Config tab. Enter the default gateway address
6. Click on PC-C and select the Config tab. Enter the default gateway address