Download presentation
Presentation is loading. Please wait.
Published byDortha Perry Modified over 6 years ago
1
1. Make sure supply voltage is off, unplug the USB, and close the GUI.
2. Plug in the USB cable to the EVM through the J1 micro-USB connector. 3. Plug in the other end of the USB cable to the computer USB port. 4. Ensure that VSYS (3.3 V to 5 V) is connected to the pin labeled VSYS of P16 and that GND is connected to the pin labeled GND of P16. 5. Set supply voltage to between 3.3 V and 5 V with an appropriate current limit. Turn on supply voltage. The RESET_OUT LED (D1), LDOVRTC_OUT LED (D3), POWER_HOLD LED (D5), LDOVRTC_OUT, and POWER_GOOD (D2) should light.
2
To Host PC GND 5V
3
6.Start GUI 7.Click bit of register on GUI (For example, The red circle below)
4
8.Errer occur 9.Click [Continue] bottom
5
8.Error does not occur after clicking [Continue] bottom at first error.
Similar presentations
© 2024 SlidePlayer.com. Inc.
All rights reserved.