1. Power Capacitors

2. Outline Definition Power capacitor applications
Typical applications of:
Series capacitors
Shunt capacitors
Capacitor Placement / Sizing
Standards
WEIHUA WANG 2

3. Definition
Power System Capacitor is an assembly of dielectric Materials and Metal-electrodes in a container (casing), with terminals brought out, that is intended to introduce capacitance into an electric power circuit. [1]
WEIHUA WANG 3

4. Fig.1 Power Capacitor in Service[2]
WEIHUA WANG 4

5. Nature of the power capacitors
The power capacitor can be considered to be a VAR-GEN (reactive power Source), since it actually supplies needed-magnetizing current requirements for inductive loads.[3]
The fundamental function of power capacitor is to provide needed reactive power compensation.
WEIHUA WANG 5

6. Motivations
The first use of capacitors on power circuits was in 1920.[4]
The initial motivation for power capacitor application was for power factor correction.
Until present, Fixed- shunt capacitor banks for Power Factor Correction has been a well established approach.
WEIHUA WANG 6

7. Motivations Power factor correction Feeder-Loss Reduction
Release of System capacity
Voltage- Stabilization/Regulation
Efficient Power Utilization
Power Quality Enhancement
Power Harmonic Filtering
WEIHUA WANG 7

8. Series Capacitors
Series capacitors are used on transmission lines to compensate for inductive reactance/ Enhance Power Transfer.
It is best to think of series capacitor as voltage regulator which regulate Series voltage (Boost/Buck) based on polarity and Bank Size.[5]
Series capacitor can be used as a blocking filter for offending harmonics
WEIHUA WANG 8

9. Series Capacitors
For steady state Power Flow and transient state stability, the real power flow (P) over a transmission line is given by formula (1), where Es is the sending end voltage, ER is the receiving end voltage, X is the line reactance and β is the angle between Es and ER .
WEIHUA WANG 9

10. Series Capacitors
The power transfer can be increased considerably by the use of series capacitor banks.
Series capacitors are suited practically to circuits where light flicker is encountered due to Dynamic load fluctuations, such as frequent inrush motor starting, electric welders and arc-furnaces.
WEIHUA WANG 10

11. Shunt Capacitors[5]
The shunt capacitors are used to supply a Capacitive type-Leading VAR reactive power to the AC Power system at the point of Connection, in order to:
WEIHUA WANG 11

12. Shunt Capacitors[5]
Reduce the lagging component of the circuit current
Increase the voltage of the load bus
Improve bus-voltage regulation and/or power factor
Reduce Transmission losses
Reduce Electricity Billing cost based on KVA Demand
WEIHUA WANG 12

13. Switched-Type Capacitor
A lot of dynamic/adaptive controller are used to switch or modulate Capacitor- Banks connected to the AC-systems.
Schemes are employed to change the compensation Level/topologies of the Capacitor Banks based on Load-voltage and current variations / excursions or sudden system faults.
WEIHUA WANG 13

14. Capacitor Placement
The Capacitor Location or Placement for low voltage systems determines capacitor type, size, location and control schemes.
Optimal capacitor placement is generally a hard combinatorial .optimization problem that can be formulated as a nonlinear/Search Minimization problem.[6]
WEIHUA WANG 14

15. Capacitor Placement
Almost all the methods to solve capacitor placement problems are based on the historical data of the load models and associated cost of the energy and the cost of capacitor banks.
Cost $/Kvar for Power savings and Losses (Power losses/Energy losses)
WEIHUA WANG 15

16. Capacitor Placement
However, Historical Data and Load models are uncertain and may change in reality.
To account for such load model and load pattern/cycles uncertainties Soft- Computing AI Based algorithms using fuzzy sets/Neural networks/Genetic Algorithm can be utilized.[7]
WEIHUA WANG 16

17. Capacitor Placement
In general, capacitor placement problems can be solved in two steps:[8]
Use of load flow model and find the V,P,Q at all the buses and also the feeder losses
Minimize the cost function-Jo-min - subject to constraints, like practical limits of voltage and capacitor size!
WEIHUA WANG 17

18. Limitations and Cautions
Resonance-Series or Shunt Type
Capacitor inrush current transients caused by Capacitor Switching
Capacitor Sinking harmonic currents
Transient Recovery Voltage
WEIHUA WANG 18

19. Resonance
Resonance is a condition whereby the capacitive reactance of the AC-System, offsets its inductive reactance leaving only the resistive elements in the AC- Network as the only impedance.
The resonant frequency can be calculated by as
WEIHUA WANG 19

20. Resonance
If the resonant frequency happens to coincide with one generated by an existing harmonic source, then the dangerous voltages and currents will increase disproportionately, causing damage to capacitors and other electrical equipments. [3]
WEIHUA WANG 20

21. Capacitor Switching Transients
Capacitor switching transient typically occurs when energizing a large capacitor on the high voltage side of the power system (the utility side) result in magnification/intensification of the transients at lower voltage capacitors.
The magnified transient at lower voltage end can reach up to 400%.
WEIHUA WANG 21

22. Standards
There are two standards provide a basis for uniformity in design and testing of shunt power capacitors:
IEEE Std IEEE Standard for Shunt Power Capacitors
IEEE Std IEEE Standard for Series Capacitors in Power Systems
WEIHUA WANG 22

23. Conclusion
Power capacitor are very useful for power factor correction, loss reduction, voltage profile improvement and distribution system-capacity release/increase.
Best location and sizing of the capacitor bank should be carefully selected.
WEIHUA WANG 23

24. Reference
[1] IEEE standards, IEEE Standard for Shunt Power Capacitor, IEEE Std
[2]
[3] M.H.Shwehdi and M.R.Sultan, “Power Factor Correction Capacitors; Essentials and Cautions”, IEEE Power Engineering Society Summer Meeting, Vol.3, pp
[4] S.W.Cichanowaki and G.R. Newcomb, Power Capacitors, Electrical Electronics Insulation Conference, Boston '91 EEIC/ICWA Exposition, Prodeedings of the 20th
WEIHUA WANG 24

25. Reference
[5] Dr. G. Thomas Bellarmine, Optimum Series Compensated High Voltage Transmission Lines, Southeastcon '97 'Engineering New Century', Proceedings, IEEE April 1997 P
[6] Ramon A. Callego, Alcir Jose Monticelli and Ruben Romero, “Optimal Capacitor Placement in Radial Distribution Networks”, IEEE Transactions on power systems, Vol.16, No.4, November 2001
[7] H.N.Ng.M.M.A.Salama, “Fuzzy Optimal Capacitor Sizing and Placement”, Electrical and Computer Engineering, Canadian Conference on Vol.2, 5- 8 Sept P
WEIHUA WANG 25

26. Reference
[8] A.M.Sharaf and S.T. Ibrahim, “Optimal capacitor placement in distribution networks”,1996 Electric Power System Research 37,
WEIHUA WANG 26