1. TEMS Basic Steps
Presentation-gsm Positioning-map Configuration-general-load Cell File
Logfile-recording Properties-desktop-new Folder-ms1 Dedicated Name Of Folder-all Log Files In It ,Idle,dedicated Both
Map-theme Setting-cell Layer-cell Theme-cell Label Add
Layer Properties-give Route Of DT Add
GPS Attach-f2 Connect
Mobile Attach:
Msi-connect-dedicated,ms2-connect-idle(f2),ms3-connect In Scaning Mode(ms3-scanning-properties(decode Bsic-check Mark,write Ufone Channels)-start
Control-command Sequence-edit-voice-dial-give Values-(time Interval=90sec)
Drive Start
Record-(save Log File)-run –Stop Recording……in Each Route Do This Stp-remove Mobile
Log File-export Log File-add Input File(log File Where We Save)-add All Log Files-output-merge Output-prefix-ms1 Dedicated-run
Now Mapinfo File Generated
Log File-report Generated-add All Log Files/Report Generated KPI

2. Layer 3 Messages=rf(air Interface) Messages Like Synch Channel ,Paging Channel Request Info Etc
Layer 2 Messages=events Like Call Established, Call Setup Etc
Mode Reports=ul/DL Measurement Reports