1. Applications of Newton’s Laws of Motion
Equilibrium: no net force
Draw a simple diagram
Draw a free body diagram for one body
Identify interactions (force magnitudes and directions on that body)
Choose coordinates and determine the components of each force
Set algebraic sum of all x-components to zero to obtain an algebraic relation. In a separate equation set all the y-components equal to zero.
Repeat 2-5 for any other bodies in the problem.
Use all the simultaneous equations from the step(s) 5 to solve for the unknowns.

2. A car engine of weight w is suspended from a chain linked to two other chains as shown. One chain is fastened to the ceiling and makes a 60° angle with respect to the ceiling. The other is horizontal and attached to the wall. What is the tension in the chains in terms of the weight of the engine?
60o

3. Components of weight and ramps parallel and perpendicular componentsq q a a

4. Tension over a frictionless pulley: A weight w1 slides on a frictionless 15o slope. A cable attached to the weight is also attached over a pulley to a counterweight w2 chosen to just counter balance w1, so that the entire system moves at constant velocity. Determine w2 in terms of w1. w1
15o w2

5. Dynamics: Draw a simple diagram Draw a free body diagram for one body
Identify interactions (force magnitudes and directions on that body)
Choose coordinates and determine the components of each force
Set algebraic sum of all x-components to max to obtain an algebraic relation. In a separate equation set all the y-components equal to may.
Repeat 2-5 for any other bodies in the problem.
Use all the simultaneous equations from the step(s) 5 to solve for the unknowns.

6. An iceboat (mass including rider is 200 kg) is initially at rest on a horizontal surface. What force must be applied to the boat to accelerate it to a speed of m/s in 4.00 s if the opposing frictional force has a constant magnitude of 100 N?

7. An elevator and its load have a total mass of 800 kg
An elevator and its load have a total mass of 800 kg. The elevator is originally moving downward at 10.0 m/s. The elevator is brought to rest over a distance of 25.0 m. What is the tension in the supporting cable?
A 50.0 kg woman stands on a scale while riding in the elevator in the previous example. What is the reading on the scale while the elevator is coming to a stop? What is the reading once the elevator is at rest?

8. A sled rides down a frictionless surface which makes an angle with respect to the horizontal. What is the acceleration of the sled?

9. A mass m1 slides on a frictionless horizontal surface
A mass m1 slides on a frictionless horizontal surface. A mass less cable attached to m1 is also attached over a pulley to a counterweight m2. Determine the acceleration of the masses and the tension in the cable. m2 m1

10. A simple accelerometer is made by suspending a weight by a string from the center of a level protractor. Given the mass m of the suspended object and the angle  that the string makes with respect to the vertical, determine the acceleration a. 

11. due to surfaces sticking together
Friction
opposes motion
due to surfaces sticking together
Kinetic Friction: surfaces are moving relative to each other
a.k.a. Sliding Friction
Static Friction: surfaces are not moving relative to each other.
Static Friction prevents stationary objects from moving until sufficient force has been applied.
Rolling Friction, etc
Applied Force
Force of friction

12. Coefficient of Friction Frictional forces depend upon
how hard the surfaces are being pressed together
-> force perpendicular to the surface = normal force (FN)
the types of surfaces that are in contact
-> coefficient of friction
Material static: s kinetic: k
wood on wood
wood on stone
steel on steel (smooth)
rubber tire on dry concrete
rubber tire on wet concrete
steel on Teflon
see also table 5-1

13. A 500 N crate is dragged by a rope across a horizontal surface
A 500 N crate is dragged by a rope across a horizontal surface. To start it moving takes 230 N of horizontal force. Once moving, it takes 200 N to keep it moving at constant speed. What are the coefficients of friction?
What is the friction force if the crate is at rest and a horizontal force of 50 N is applied to it?

14. What is the force necessary keep the crate moving at constant velocity if the rope is pulled at an angle of 30o above the horizontal?

15. What angle should the chute make with respect to the horizontal?
A chute is being built along which crates are to be slid down at constant speed. The coefficient of kinetic friction is k.
What angle should the chute make with respect to the horizontal?
What is the acceleration of a moving crate if the angle is actually greater than this critical angle? 

16. Fluid resistance: force on a body moving through a fluid (gas/liquid)
always opposes motion
low speeds: force is proportional to speed f  v
f = k v : k depends upon fluid, geometric size/shape of body
high speeds: force is proportional to speed2 f  v2
f = D v2 : D depends upon fluid, geometric size/shape of body
terminal velocity:

17. Dynamics of Circular Motion recall now apply Fnet = m arad
net force is directed towards the center of the circle!
A .300 kg mass revolves uniformly on a frictionless horizontal surface. The mass is attached to a .140 m cord tied to a pin at the center of the circle. What is the tension in the string if the mass makes 2.00 revolutions per second?

18. A conical pendulum consists of a mass m suspended from a fixed length L of string. The mass swings in a horizontal circle so that the string always makes an angle  with respect to the vertical. How are the speed and the period related to the parameters specified above? 

19. A circular curve of radius R is to have a flat roadbed
A circular curve of radius R is to have a flat roadbed. The coefficient of static friction between the tires and the road is s. What is the maximum speed vmax, the car can go around the corner without slipping?
phys

20. A circular curve of radius R is to have a banked roadbed so that for a speed v, the car will not need any force of friction to make the curve. Relate the angle of bank to the speed of the car and radius of the curve.
phys

21. Motion in a Vertical Circle mass on a string
minimum speed
speed increasing
maximum speed
speed decreasing r
h = 2r
At the top:
At the bottom:
Critical speed: speed at top at which string goes slack (T=0)
+ applications to amusement park physics

22. Fundamental Forces
Gravitation (interaction between masses)
Electromagnetism (interaction between charges)
unified force: electrostatics + magnetism + …
for interacting protons, 35 orders of magnitude stronger than gravity
Strong Interaction (aka the Strong Nuclear force)
short range
Weak Interaction (aka the Weak Nuclear force)
further successful unification: Electroweak theory
Strong + Electroweak = Grand Unified Theory (GUT)
all four unified = Theory of Everything (TOE)