1. This presentation is not meant to be a reference.
All info is culled from the TI-SDO and the below links should be used as reference:
Twiki snapshot created as DebugTraceToolsTwiki.pdf
Twiki snapshot created as NetraDebugToolsTwiki.pdf
Install CCS from below link as as a fresh installation  
Install emupack from below link on top of the CCS installation
ftp://ftp.hou.asp.ti.com/pub/sdo/emulation/releases/ /ti_emupack_setup_ exe  
After installation, Select the “Netra – Spectrum Digital XDS560V2 STM USB Emulator” target configuration.

2. Launch the Netra Target Configuration now
To enable launching of CS_DAP_Debug_SS core:
Select Windows -> Preferences
Enable “Show non-processor devices” option and apply
Launch the Netra Target Configuration now

3. Load CortexA8 System Initialization GEL file
Select A8 Target
Right Click & select
“Open GEL File View”
Load the system initialization GEL
Load CortexA8 System Initialization GEL file

4. Load CS_DAP_DebugSS STM enable GEL
Select CS_DAP_DebugSS Target
Right Click & select
“Open GEL File View”
Load the STM enable GEL
Load CS_DAP_DebugSS STM enable GEL

5. Connect to CortexA8 Target
Execute the CortexA8 GEL System Init GEL.

6. Execute the CS_DAP_DebugSS GEL to enable STM Trace

7. Set Focus to CSSTM_0 by single clicking on CSSTM_0 core

8. Connect Target CSSTM_0 Core (Right Click and Choose Connect Target)

9. Select the Trace Control Menu

10. Trace System Control Tab Configuration
Select the configuration as depicted in screen shot below
Select the “Receiver” button

11. Trace Control Menu – Select Receiver. Set to 560 V2 Trace
Select OK on “Select Receiver” Tab and Parent “Trace Control System” Tab

12. Set a Trace Breakpoint Menu
Ensure CSSTM_0 core is selected
New Breakpoint -> “Trace”

13. Edit the Trace Breakpoint Menu Properties
Right Click to get context menu and choose “Properties”

14. Trace Breakpoint Menu Properties
Set STM Trace Type to “Performance Probe”

15. Trace Breakpoint Menu Properties
Set Use Case to “Throughput per Sampling Period”

16. Trace Breakpoint Menu Properties – Select EMIF0 Write
Select OK to complete Trace Breakpoint Configuration

17. You can create another breakpoint following the same procedure and monitor
another subsystem.
For example: Trace Breakpoint Menu Properties – Select EMIF1 Read

18. Enable Trace Breakpoint

19. Launch Trace Analyzer

20. Trace Analyzer Window will now be displayed
You can now load and run your application.
On clicking “STOP” the DDR stats data will be rendered on the “Trace Window Display”

21. Sample Output of DDR stats analyzer