1. Flex Series & View Series
GLASS MEASURING GUIDE
Flex Series & View Series

2. Measuring Glass For Flex Series
-1/8”
For the FLEX SERIES: Measure from stud bead to stud bead then subtract 1/8” as shown above.

3. Flex Series Track to Stud
Measuring Track to Stud
Setting the Glass
GLASS
When measuring Track to Stud, place your tape measure inside the bottom track and measure up to the stud bead and subtract 1/8” as shown in the picture.
When setting the glass: first set the glass down into the bottom track (as shown) and rest the glass against the stud bead. The finish trim will snap into the stud and hold the glass firmly in place.
-1/8”

4. Clerestory
GLASS
When measuring a clerestory, place your tape against the stud bead and measure up to the top track like shown in picture and add a 1/2".
+1/2
Example of how the glass sets

5. Flex Series Full Height Glass
Place your tape measure into the top of the top track against the track bead and measure down to the top of the bottom track and subtract an 1/8" or 1/4" depending on the levelness of the floor.
Note: if the floor is really out of level you can order a trapezoid pane of glass if needed.
GLASS
-1/8" or
-1/4"
When measuring for Flex Series full height glass you will need to measure both sides of your opening and adjust your measurement appropriately.
1/2
Shim

6. Vertical Glass Measurements
View Series
Vertical Glass Measurements
Screw
Screw
When measuring the vertical measurements of the View Series, place your tape measure on the head of the screw in the top track and measure to the very top of the bottom track and subtract 1/4”.
You will want to take multiple measurements along the length of your track.
GLASS
-1/4"
Shim
Example of Installed Glass

7. View Series Horizontal Glass Measurements
If your project has between 2 and 6 panes of glass in a partition you will need to measure the VO (visual opening) and add a 1/2” to your overall measurement, then divide by the number of panes of glass you have.
For example: If I had 4 panes of glass and my VO was /2” = 96 1/2 then divide by 4 = 24 1/8 for four panes of glass.
When measuring for a single side light, you will measure the visual opening and add 3/4”
Glass
Note: If you have more than 6 panes of glass consult with the NxtWall team on how to measure the Width of your opening.