1. Microwave Motion Activator I (Automatic Door Sensor)
DNA-200B
■ Instruction Manual
Thank you for purchasing this product.
You are requested to use right, reading this instruction manual before use.
■ About Product:
This sensor is a Microwave automatic door sensor applied
Doppler radar principle.
Please supply a voltage of AC/DC 9V ~ AC/DC 24V.
It is possible to use in any circumstances and has few wrong
operation.
(It is reliable as it's not detected by shaking any paper or
newspaper.)
The detecting method is able to be setting as 3 level.
When forward, it is setting as following : Sensitivity Level 1.
(Accessories)
1. 2 screws for fixing.
2. A flexible cord with length of 1.5m.
3. A instruction manual.
4. A Installation Paper.
■ Specification
Specification
Type
POWER SUPPLY
AC/DC 9V ~ AC/DC24V
POWER CONSUMTION
: STANDBY / OPERATION /
MAINS FREQUENCY
50 ~ 60Hz
FREQUENCY
10.525GHz etc.
RELATIVE HUMIDITY
0 ~ 95 %
FUNCTION INDICATION
LED
MOUNTING STYLE
WALL
TIME DELAY/HOLD TIME
REAL TIME / 0.5 SEC
MOUNTING HEIGHT
2.0M ~ 2.50M
RANGE (Level 1 ~ Level 3)
0.0M ∼ 2.0M
DIMENTION(W*H*D)
140 * 63 * 43mm
OPERATING TEMP
- 25'C ~ +60'C
WEIGHT
120g
DETECTION ANGLE
40' ~ 160'
COVER COLOR
BLACK, SILVER
■ Attentions for Installation.
* The use of this product is the Indoor.
* This sensor has to be fixed not to sway.
* Any fluorescent material must not to be in the detecting zone
of this sensor.
* Any mobile or vibratile object must not to be in the detecting
zone of this sensor.
* And, in case you dismantle product cover, please use
screwdriver and grooves on the both sides to dismantle.
If you don’t use those to dismantle by force, it may cause any
damage on the product.
■ Installation Method.　
When make a hole in the wall for installation, to prevent an accident previously,
Please confirm if there is not electric wire of other machineries in and around.
At first, open the box and please confirm the accessories.
Step 1 : please fasten a paper for installation on a position to install and please make holes with
diameter of 3.5mm, a hole of wire with diameter of 10mm, in the indicated position of the paper.
Step 2 : please remove the cover with screwdriver.
Step 3 : please fasten the sensor body on the wall with the inner screw.
■ Establishment location of sensor.

2. Step 4 : please connect a wire of the body of sensor and a wire of automatic door system.
The yellow wire is for output, gray is for power.
The wire for power has not polarity(+,-).
Step 5 : please set in moderation according to circumstances
as below setting method.
Step 6 : please fasten the connected wire on the body and
unite the cover with body.
Please set right for general operation of this product.
All settings are adjusted by the ‘DIP Switch’.
* Setting method of the sensitivity and detecting distance.
■ Opening the Sensor Cover
■ Description of the Sensor
■ Setting Method.
Yellow(COM)
Yellow(N/O)
Grey(AC/DC)
* A sensing distance can have some difference(+/- 20cm) according to a moving object.
■ The Detecting Range:
Dnet Co.,Ltd.
Homepage :
Tel: , Fax: