1. European Modelbased Definition TC Face to Face Meeting on May 7th
MBD Status at Festo
European Modelbased Definition TC
Face to Face Meeting on May 7th

2. Feedback from User experience
Too many combine views confuses user
Threads are not found by nonCAD User (Creo or Creo View)
Annotations from sketch confuse nonCAD user
Creating Annotation in 3D are time consuming
The GTOL and datum tag functions show different behaviour in 2D and 3D
E.g. This is only possible in 2D not in 3D 3D

3. Tooling section starts MBD (CHIP)
Creo 2.0
Creo View 3.0
Mostly color based communication with supplier
Tolerance is descript by a color table

4. C12493770 / SPR2261576: Annotation visibility at drawing
Shown 3D annotation from a sketch can not be displayed in 2D
2D  annotation is missing
3D MBD

5. Unexpected behavior of layer in drawing and 3D model
Creo creates rule based layer by himself, causes unexpected behavior.
Start
Place view
Rule based layer
Created by Creo

6. Problem placing symbols in 3D model
Symbols for additional information
Symbol with standard symbol function &dim can not be used in 3D
Definition of customer’s specific surface symbol not possible, according to the standard PTC surface symbols
Customer
symbol
PTC
standard

7. Improvements based on user experience
Combine the combine views for each group of user, e.g.
designer with surface modeling technics
draftsman  3D drawing creating
Detail engineer
NonCAD User (Creo View), e.g. quality engineer
Expert, e.g. FEM engineer
Thread surface should be marked by color
Festo
Colored thread
PTC
standard

8. GTOL / datum Tag according to ISO 1101 and other
New ISO standard not supported in Creo 2.0
Different behavior between 3D and 2D
Add marking for quality marking on GTOL symbols according to FN940084
Best practices of others?

9. Future plans Windchill update 10.2 2016
Validation Creo View 3.0 in 2015
Starting project of CAQ with MBD in 2016
Workshop end of September with PTC?

10. Improvements requests by Festo
Group function for combine views
Surface color for combine views (volume / surface)
Add sketch (cosmetic / datum) to combine views
Add surface to combine views
Full support for ISO 1101
Improvement for thread visibility in 3D
Symbols
Placement of surface
Full support of 2D function

11. question?

12. Thank you for your attention