1. SOLID STATE RELAY WITH ZVS PROPERTIES ANALYZED ON CRO
SUBMITTED BY
EDGEFX TEAM

2. ABSTRACT
Each phase is controlled individually by a power triac with optional snuber network (RS, CS) and an optically isolated triac driver with current limit by a constant current arrangement
microcontroller is used to generate output pulses after zero voltage pulse to verify as to whether the load is getting the switched on at zero cross of the supply wave form or not.

3. BLOCK DIAGRAM

4. HARD WARE EQUIPMENTS POWER SUPPLY BLOCK
POWER SUPPLY BLOCK
MICROCONTROLLER (AT89S52/AT89C51)
LED
PWM
MOSFET
BC547
1N4007
RESISTORS & CAPACITORS

6. EMBEDDED SYSTEMS Definition for :- EMBEDDED SYSTEMS
A combination of hardware and software which together
form a component of a larger machine.
An example of an embedded system is a microprocessor that
controls an automobile engine.
An embedded system is designed to run on its own without
human intervention, and may be required to respond to
events in real time.

7. EMBEDDED SYSTEMS

8. AT89S52 MICRO CONTROLLER Compatible with MCS®-51 Products
8K Bytes of In-System Programmable (ISP) Flash Memory
4.0V to 5.5V Operating Range
Crystal Frequency MHZ
Three-level Program Memory Lock
256 x 8-bit Internal RAM
32 Programmable I/O Lines
Three 16-bit Timer/Counters
Eight Interrupt Sources
Full Duplex UART Serial Channel
Watchdog Timer
AT89S52

9. PIN DIAGRAM OF AT89S52

10. PWM
The PWM switching frequency has to be much faster than what would affect the load, which is to say the device that uses the power.
The term duty cycle describes the proportion of on time to the regular interval or period of time;
a low duty cycle corresponds to low power, because the power is off for most of the time. Duty cycle is expressed in percent, 100% being fully on.

11. PWM APPLICATIONS Telecommunications Power delivery Voltage regulation
Audio effects and amplification.

12. ZVS
Zero voltage cross detection means the supply voltage waveforms pass through zero for every 10msec. that means as we are using 50Hz ac signal the total cycle is 20ms.in that for every half cycle (i.e. 10ms) we will get zero signals
ZVS detection we are getting zero voltage pulses. We are applying these pulses to microcontroller
microcontroller gets these pulses then only the microcontroller is irrupted and it will perform the required/assigned operation.

13. ZVS WAVE FORM

14. MOSFET
Metal–Oxide–Semiconductor field-effect transistor (MOSFET, MOS-FET, or MOS FET)
MOSFET is a device used for amplifying or switching electronic Signals

15. MOSFET as a switch & P- Type , N-Type MOSFET

16. BC547 The BC547 transistor is an NPN Epitaxial Silicon Transistor.
The BC547 transistor is a general-purpose transistor in small plastic packages.
It is used in general-purpose switching and amplification BC847/BC547 series 45 V, 100 mA NPN general-purpose transistors.
Whenever base is high, then current starts flowing through base and emitter and after that only current will pass from collector to emitter

17. SOFTWARE REQUIREMENTS
PROGRAMMING LANGUAGES Embedded C , ALP (Assembly Language) COMPILERS: Keil 2.0/3.0uv DUMPING SOFT WARE: Using Micro controller flash Software we are dumping our HEX Code into Micro Controller

18. KEIL COMPILER WINDOW

19. BIBILOGRAPHY
The Microcontroller and Embedded systems” by Muhammad Ali Mazidi and Janice Gillispie Mazidi , Pearson Education.
ATMEL 89S52 Data Sheets.

20. THANK ‘Q’