1. AN/PRC 150 Tactical Radio
SPC BELL
SPC CHAVEZ

2. Programming the radio The First step is to turn on the radio
Pull on the knob lightly and turn to PT
Wait for the radio to go through its internal checks

3. Programming the radio Press the 8 (PGM) key
Press the right arrow button until MODE is highlighted
Press the ENT button
PRESET should be highlighted press the ENT button
CHANNEL should be highlighted press the ENT button

4. Programming the radio
Now choose an unoccupied channel number by using the number buttons in this case press 001 then ENT button
For RX FREQUENCY type in this will be our frequency for today. Press the ENT button.
For TX FREQUENCY type in this will be our frequency for today. Press the ENT button
RX (receive) TX (transmit)

5. Programming the radio Modulation scroll down to FM and press ENT
RX ONLY leave at NO press ENT
LIMIT MAX TX POWER leave at NO press ENT
ENABLE SSB SCAN leave at NO press ENT

6. Programming the radio Press the 8 (PGM) key
Press the right arrow button until MODE is highlighted
Press the ENT
PRESET should be highlighted press the ENT
Scroll over to SYSTEM Press ENT

7. Programming the radio SYSPRE1 should be highlighted press ENT
Type in name for today we will leave it at SYSPRE1 Press ENT
Leave RADIO MODE at FIX press ENT
Now enter the channel number that we used for our frequency earlier 001

8. Programming the radio Leave MODEM PRESET OFF press ENT
For ENCRYPTION TYPE scroll down to NONE press ENT
Leave PT VOICE MODE at CLR
For CC/CT VOICE MODE scroll done to NONE
Leave ENABLE at YES

9. Programming the radio Press CLR until you are at the radio screen
Scroll over until the CHAN number is highlighted and scroll up or down to the channel that we used for our frequency press ENT
To check to make sure that everything was entered correctly Press the 0 button and it will show the all the information.
Now do a radio check