1. Performance PlusTM Hardwood
Locking Installation
Fastest and easiest Hardwood floor installation saves time and money
Eliminates the need for glue, nails or staples
Wider width faster installation
Walk on floor immediately after installation
Easy installation with the option later for an easy removal
Can be used with VapArrest this provides easy solution to concrete moisture issues
A 1/2” expansion space required for locking Installation
Installation will begin at the left wall with your tongue facing the wall or starter row
When installing engage the side joint first
Slide to your left then engage your end joint
Do not attach Trims or Moldings to the flooring material
When installing do not attach the flooring to the subfloor at any point during the installation
Lock N Fold technology provides greater options on what type of substrates the product can be installed over

2. Performance PlusTM Hardwood Glue Down Installation
Use Armstrong ProConnect Premium Flooring Adhesive Or Armstrong 57 Premium Urethane adhesive
A ¼” expansion space required for Glue Down Installation
Installation will begin at the left wall with your tongue facing the wall or starter row
When installing engage the side joint first
Slide to your left then engage your end joint
Do not slide the hardwood in the adhesive
During the installation occasionally remove a piece of flooring and inspect for proper adhesive transfer
Clean adhesive from the flooring frequently using Low Oder Mineral Spirits
Stagger end joints approximately 6 inches
Avoid installing on the surface of the flooring
To eliminate minor shifting or gapping during the installation use 3M 2080 blue tape
Do not let tape on the surface for more that 24 hours
Do not let adhesive residue on the surface for more than 24 hours
Avoid heavy foot traffic for 24 hours

3. Performance PlusTM Hardwood Staple Down Installation
Use only Bostich Model 2025K fastening machine
A ¼” expansion space required for Staple Down Installation
Installation will begin at the left wall with your tongue facing the wall
When installing engage the side joint first
Slide to your left then engage your end joint
Use 1” 20 gauge staples
Before the installation make sure your air compressor is set properly, staples should be engaged just below the surface of the GROOVE
Staple 1” to 2” from the ends and then every 3” to 4”
Stagger end joints approximately 6 inches
Avoid using any other fastening machines staples they will not engage properly
Wall to wall installation only
A Brad nailer may be used to blind nail the first row