Presentation is loading. Please wait.

Presentation is loading. Please wait.

C6 What voltage does the scope measure across the lower 1 MW resistor if you set the scope to 50 W impedance? 1MW 0 V 2.5 V 3.3 V 5 V 7.5 V 10V 1 MW.

Similar presentations


Presentation on theme: "C6 What voltage does the scope measure across the lower 1 MW resistor if you set the scope to 50 W impedance? 1MW 0 V 2.5 V 3.3 V 5 V 7.5 V 10V 1 MW."— Presentation transcript:

1 C6 What voltage does the scope measure across the lower 1 MW resistor if you set the scope to 50 W impedance? 1MW 0 V 2.5 V 3.3 V 5 V 7.5 V 10V 1 MW

2 When Vin is a constant DC value, the capacitor behaves in the steady-state RC circuit most like:
A wire. An open switch. A resistor of resistance R. A light bulb. E) Totally different from any of the above.

3 Which circuit has a larger value of  = R∙C ?
D6 Which circuit has a larger value of  = R∙C ? A B Vin,out(t) t R A B) B C) They are the same. D) Impossible to tell from given information. C

4

5 Consider the low-pass filter at right
Consider the low-pass filter at right. When ω >> ω3dB, the phase shift of Vout with respect to Vin is approximately: A) 0 B) π/4 -π/4 π/2 E) -π/2 Note: “+” means the output is behind “-” means the output is ahead t sin(ωt) sin(ωt+ϕ)

6

7 For the circuit below, it is observed that Vin >> Vout
For the circuit below, it is observed that Vin >> Vout. The shape of Vin is shown at right. Which of the choices best represents Vout? (Note: Vertical axes not to scale.)

8

9 Q  1 Q  10 Q  100


Download ppt "C6 What voltage does the scope measure across the lower 1 MW resistor if you set the scope to 50 W impedance? 1MW 0 V 2.5 V 3.3 V 5 V 7.5 V 10V 1 MW."

Similar presentations


Ads by Google